Assa Abloy Corbin Russwin 9903 Series Manual

*9903 and *9905 Series
HEAVY DUTY ELECTRICALLY
CONTROLLED TRIM
For use with ED5000 Series Exit Device (Wood and Metal Doors)
Combine simplicity, security and access control in a robust and elegant design with the redesigned Corbin Russwin *9903 and
*9905 series electrically controlled exit trim. Utilizing the patented free wheeling system, the redesigned Exit trim provides
electrified remote locking and unlocking.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Attention Installer
Please read these instructions carefully to prevent
missing important steps.
Please Note: Improper installations may result in
damage to the lock and void the factory warranty.
Important: The accuracy of the door preparation
is critical for proper functioning and security of
this lock.
Misalignment can cause premature wear and a
lessening of security.
Escutcheon Assembly
Lever is handed, LHR (shown) or RHR.
Note: Lever Return Spring is handed. Hand
or trim cannot be changed without correct
spring.
LHR, part number 651 F61-8 (Red)
RHR, part number 651 F62-8 (Blue)
1. Check cylinder components.
NOTE: Cylinders longer than 1-1/8" (29mm) will require collars.
Refer to Corbin Russwin Cylinder Collar Chart on this page.
2. Doors with a thickness larger than 1-3/4" (44.5) requires a
larger tailpiece.
Refer to Corbin Russwin tailpiece chart on this page.
3. Assemble cylinder.
Insert cylinder housing prongs into matching notches of escutcheon.
Pass cylinder tailpiece thru cylinder collar (when required) and slot in
cylinder housing cam.
Fasten cylinder in escutcheon recess or collar using (2) mounting screws.
DO NOT OVERTIGHTEN SCREWS
* Represents prefix letter(s) for various lever designs.
For Technical Assistance call Corbin Russwin at 1-800-810-WIRE (9473)
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
2 STUDS TOWARDS
LOCK EDGE
(2) 1/4-20 Pan Head
Machine Screws
Packed with device
(2) #14 Finishing Washers
2 STUDS AWAY FROM LOCK
1
Cylinder Collar
(when required)
(2) Cylinder Mounting
Screws Supplied
with Cylinder
Cylinder Housing Cam
*9903 ESCUTCHEON
ASSEMBLY
(FAIL SAFE)
Corbin Russwin
Cylinder Collar Chart
Cylinder Length
1-1/8" (29)
1-1/4" (32)
1-1/2" (38)
** Specify finish
Corbin Russwin Tailpiece Chart
Door thickness
1-3/4" (44.5)
2" to 2-1/4" (51 to 57)
WARNING
This product can expose
you to lead which is
known to the state of
California to cause cancer
and birth defects or other
reproductive harm. For
more information go to
www.P65warnings.ca.gov.
08/2018
Rim
Cylinder
Collar
None
654F07 **
654F08 **
Tailpiece
789F908 (standard)
789F918
FM211
10/18