Serial Ata (Sata) Hard Disks Installation; Driver Installation Guide; Untied Overclocking Technology - ASROCK CONROE865GV User Manual

ATX 12V Connector
(4-pin ATX12V1)
(see p.11 No. 2)
2.10 2.10 2.10 Serial A 2.10 2.10 Serial A Serial A Serial AT T T T T A (SA Serial A A (SA A (SA A (SAT T T T T A) Hard Disks Installation A (SA
This motherboard adopts Intel
(SATA) hard disks. You may install SATA hard disks on this motherboard for
internal storage devices. This section will guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
Before you install OS into the SATA hard disk, you need to check and
ensure the configuration of the OnBoard IDE Operate Mode option in
BIOS setup is correct according to the condition of your system. For
the configuration details, please refer to the instruction on page 31.
2.11 2.11

Driver Installation Guide

Driver Installation Guide
2.11 2.11 2.11 Driver Installation Guide Driver Installation Guide Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
drive first. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from up to bottom
side to install those required drivers. Therefore, the drivers you install can work
properly.
2.12 2.12 2.12 2.12 2.12 Untied Overclocking T Untied Overclocking T Untied Overclocking T

Untied Overclocking Technology

Untied Overclocking T
This motherboard supports Untied Overclocking Technology, which means during
overclocking, FSB enjoys better margin due to fixed PCI bus. You may set "CPU
Host Frequency" option of BIOS setup to [Auto], which will show you the actual
CPU host frequency in the following item. Therefore, CPU FSB is untied during
overclocking, but PCI bus is in the fixed mode so that FSB can operate under a
more stable overclocking environment.
Please note that it is necessary
to connect a power supply with
ATX 12V plug to this connector
so that it can provides sufficient
power. Failing to do so will cause
the failure to power up.
A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
ICH5 south bridge chipset that supports Serial ATA
®
echnology echnology echnology echnology
2 3 2 3 2 3
2 3 2 3