Guardian B7-COMFORT Instruction Manual Supplement

B7-COMFORT TOWER
CLIMBING HARNESS SEAT
Parts: 3600102, 3600103
Supplemental Instruction Manual
2. Outer Belt Loop
1. D-ring Slot
7. Side Release Buckle
Installation and Use
Step 1

Starting from the left side, feed tongue buckle belt (not shown) through D-ring slot (#1), outer belt loop
(#2), Pass-Through Buckle Receptacle (#8), seat support strap (#3), and inner belt loop (#4). Make sure
seat support strap (#3) is between inner belt loop (#4) and pass-through buckle (#8). Make sure seat
support strap (#3) is between inner belt loop (#4) and pass-through buckle receptacle (#8). Repeat on
both sides. Ensure tongue buckle belt is properly adjusted and buckled during use.
Step 2

Connect pass-through buckles (#6) to pass-through buckle receptacles (#8). Connect male end of side
release buckles (#7) to female end of seat support strap (#3) buckles and adjust to desired height by
pulling loose end of strap on both sides.
Do not throw instructions away.

Read and understand instructions

before using this equipment.
6. Pass-Through Buckle
3. Seat Support Strap
4. Inner Belt Loop
5. Seat Adjustment Strap
8. Pass-Through Buckle
Receptacle
Note: Pass-through
buckle shown
disconnected for
reference
1600132 REV. B