Table of Contents
Advertisement
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.10 No. 29)
1. High Definition Audio supports Jack Sensing, but the panel wire on the
chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
F. Enter Windows system. Click the icon on the lower right hand
taskbar to enter Realtek HD Audio Manager. Click "Audio I/O", select
"Connector Settings"
detection", and save the change by clicking "OK".
System Panel Header
(9-pin PANEL1)
(see p.10 No. 18)
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.10 No. 14)
Chassis Fan Connector
(3-pin CHA_FAN1)
(see p.10 No. 12)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.11 No. 6)
GND
This is an interface for front
PRESENCE#
MIC_RET
OUT_RET
panel audio cable that allows
convenient connection and
1
control of audio devices.
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
, choose "Disable front panel jack
PLED+
This header accommodates
PLED-
PWRBTN#
several system front panel
GND
functions.
1
DUMMY
RESET#
GND
HDLED-
HDLED+
Please connect the chassis
1
SPEAKER
speaker to this header.
DUMMY
DUMMY
+5V
Please connect a chassis fan
GND
cable to this connector and
+12V
CHA_FAN_SPEED
match the black wire to the
ground pin.
Please connect a CPU fan cable
+12V
CPU_FAN_SPEED
to this connector and match
GND
FAN_SPEED_CONTROL
the black wire to the ground pin.
1 2 3 4
2 6
2 6
2 6
2 6
2 6
Advertisement
Table of Contents
