ASROCK CONROE1333-ESATA2 - V1.0 User Manual page 21

Radeon
CrossFire TM
Edition graphics
card
Connect the DVI-DMS
cable to DMS connector
of the CrossFire
graphics card.
If you install two CrossFire
connect one end of DVI-DMS cable to the monitor, another end to DMS of one
of the CrossFire
DVI of another CrossFire
Express x4). If you install one CrossFire
compatible standard Radeon (CrossFire
motherboard, please connect one end of DVI-DMS cable to the monitor,
another end to DMS of the CrossFire
to DVI of the compatible standard Radeon (CrossFire
Step 5. Power on your computer and boot into OS.
Step 6. Remove the ATI TM
The Catalyst Uninstaller is an optional download. We recommend using this
utility to uninstall any previously installed Catalyst drivers prior to installation.
Please visit this website for the driver:
http://support.ati.com/ics/support/DLRedirect.asp?
fileIDExt=050553d40196ef109fff37cbb40aaf28&accountID=737&deptID=894
Step 7. Install the required drivers to your system. Please visit the websites below
for installing the drivers that ATI
TM
A. ATI recommends Windows
installed (If you have Windows
in your system, there is no need to download it again):
http://www.microsoft.com/windowsxp/sp2/default.mspx
B. You must have Microsoft .NET Framework installed prior to
downloading and installing the CATALYST Control Center:
http://www.microsoft.com/downloads/details.aspx?
FamilyId=262D25E3-F589-4842-8157-034D1E7CF3A3&displaylang=en
Step 8. Restart your computer.
DMS
connector
TM
Edition
TM Edition graphics cards to this motherboard, please
TM
Edition graphics cards to PCIE1 slot, and the other end to
TM Edition graphics card to AGI Express slot (PCI
TM
Edition graphics card and one
TM
Ready) graphics card to this
TM
Edition graphics card, and the other end
driver if you have any VGA driver installed in your system.
TM
recommends:
®
XP Service Pack 2 or higher to be
®
XP Service Pack 2 or higher installed
2 1 2 1 2 1
2 1 2 1
Connect the DVI-DMS
cable to the monitor
connector.
TM
Ready) graphics card.