eSATAII Connector
(eSATAII_TOP: see p.11, No. 37)
Serial ATA (SATA)
Data Cable
(Optional)
Serial ATA (SATA)
Power Cable
(Optional)
connect to the SATA HDD
power connector
USB 2.0 Headers
(9-pin USB6_7)
(see p.11 No. 18)
(9-pin USB4_5)
(see p.11 No. 19)
Infrared Module Header
(5-pin IR1)
(see p.11, No. 23)
This eSATAII connector
supports SATA data cable for
external SATAII function. The
current eSATAII interface
allows up to 3.0 Gb/s data
transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on this motherboard.
You can also use the SATA data
cable to connect SATAII_RED
(PORT 2.1) connector and
eSATAII connector.
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
power cable to the power
connect to the
power supply
connector of the power supply.
Besides four default USB 2.0
USB_PWR
ports on the I/O panel, there are
P-7
P+7
GND
two USB 2.0 headers on this
DUMMY
motherboard. Each USB 2.0
1
header can support two USB
GND
P+6
P-6
2.0 ports.
USB_PWR
USB_PWR
P-5
P+5
GND
DUMMY
1
GND
P+4
P-4
USB_PWR
This header supports an
IRTX
optional wireless transmitting
+5VSB
DUMMY
and receiving infrared module.
1
GND
IRRX
2 4
2 4
2 4
2 4
2 4