Onboard Headers And Connectors - ASROCK ALIVENF5SLI-1394 User Manual

2.7 Onboard Headers and Connectors

2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
Pin1
(see p.11, No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.11 No. 11)
IDE1
PIN1
connect the blue end
to the motherboard
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATAII Connectors
(SATAII_BLACK (PORT 1.0):
see p.11, No. 12)
SATAII_BLUE
(SATAII_ORANGE (PORT 1.1):
(PORT 2.0)
see p.11, No. 13)
(SATAII_BLUE (PORT 2.0):
SATAII_RED
see p.11, No. 15)
(PORT 2.1)
(SATAII_RED (PORT 2.1):
see p.11, No. 14)
SATAII_RED (PORT 2.1) connector can be used for internal storage
device or be connected to eSATAII_TOP connector to support eSATAII
device. Please read "eSATAII Interface Introduction" on page 29 for
details about eSATAII and eSATAII installation procedures.
FLOPPY1
Secondary IDE Connector (Black)
(39-pin IDE2, see p.11 No. 10)
IDE2
PIN1
80-conductor ATA 66/100/133 cable
These four Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
SATAII_BLACK
devices. The current SATAII
(PORT 1.0)
interface allows up to 3.0 Gb/s
data transfer rate.
SATAII_ORANGE
(PORT 1.1)
2 3 2 3 2 3 2 3 2 3
the red-striped side to Pin1
connect the black end
to the IDE devices