ASROCK ALIVENF5-ESATA2 -2943 Installation Manual page 15

2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2, No. 23)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2, No. 8)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA II Connectors
(SATAII_ORANGE (PORT3):
see p.2, No. 10)
SATAII_ORANGE (PORT3)
(SATAII_BLACK (PORT2):
see p.2, No. 11)
SATAII_BLACK (PORT2)
(SATAII_RED (PORT1):
see p.2, No. 12)
SATAII_RED (PORT1)
(SATAII_BLUE (PORT0):
see p.2, No. 13)
SATAII_BLUE (PORT0)
SATAII_RED (PORT1) and SATAII_ORANGE (PORT3) connectors can be
used for internal storage devices or be connected to eSATAII_BOTTOM
and eSATAII_TOP connectors with corresponding color to support eSATAII
devices. Please read "eSATAII Interface Introduction" on page 22 for
details about eSATAII and eSATAII installation procedures.
ASRock
80-conductor ATA 66/100/133 cable
These four Serial ATAII
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
ALiveNF5-eSATA2+ Motherboard
the red-striped side to Pin1
connect the black end
to the IDE devices
1 5 1 5 1 5
1 5 1 5