ASROCK ALIVENF5-VSTA User Manual page 35

BIOS SETUP UTILITY
Advanced
CPU Configuration
AM2 Boost
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Boot Failure Guard
CPU/LDT Spread Spectrum
PCIE Spread Spectrum
SATA Spread Spectrum
Cool' n' Quiet
Secure Virtual Machine
Enhanced Halt State
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Frequency
Processor Voltage
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This item will show when "Multiplier/Voltage Change" is set to [Manual];
otherwise, it will be hidden. The range of the value depends on the CPU
you adopt on this motherboard. However, for system stability, it is not
recommended to adjust the value of this item.
Processor Voltage
This item will show when "Multiplier/Voltage Change" is set to [Manual];
otherwise, it will be hidden. The range of the value depends on the CPU
you adopt on this motherboard. However, for safety and system stability,
it is not recommended to adjust the value of this item.
Memory Clock
This item can be set by the code using [Auto]. You can set one of the
standard values as listed: [200 MHz (DDRII 400)], [266 MHz (DDRII 533)],
[333 MHz (DDRII 667)] and [400MHz (DDRII 800)].
Flexibility Option
The default value of this option is [Disabled]. It will allow better tolerance for
memory compatibility when it is set to [Enabled].
CAS Latency (CL)
Use this item to adjust the means of memory accessing. Configuration options:
[Auto], [3CLK], [4CLK], [5CLK] and [6CLK]. The default value is [Auto].
TRCD
Use this to adjust TRCD values. Configuration options: [Auto], [3CLK], [4CLK],
[5CLK] and [6CLK]. The default value is [Auto].
TRP
Use this to adjust TRP values. Configuration options: [Auto], [3CLK], [4CLK],
[5CLK] and [6CLK]. The default value is [Auto].
TRTP
Use this to adjust TRTP values. Configuration options: [Auto], [2-4CLK] and
[3-5CLK]. The default value is [Auto].
If AUTO, multiplier and
[Disabled] voltage will be left at the
[Auto] rated frequency/voltage. If
Manual, multiplier and
[200]
voltage will be set based
[100]
on User Selection in Setup.
[Enabled]
[0.75% Hershey]
[Enabled]
[Enabled]
[Auto]
[Enabled]
Select Screen Select Screen
[Disabled]
Select Item Select Item
+- +- Change Option Change Option
x9.5 1900 MHz
F1 F1 General Help General Help
1.350 V
F9 F9 Load Defaults Load Defaults
[Manual]
F10 F10 Save and Exit Save and Exit
[x8]
ESC ESC Exit Exit
[1.500V]
3 5 3 5 3 5 3 5 3 5