Jumpers Setup - ASROCK ALIVENF5-VSTA User Manual

2 . 5 2 . 5 2 . 5

Jumpers Setup

Jumpers Setup Jumpers Setup
2 . 5 2 . 5 Jumpers Setup Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on pins,
the jumper is "Short". If no jumper cap is placed
on pins, the jumper is "Open". The illustration
shows a 3-pin jumper whose pin1 and
pin2 are "Short" when jumper cap is placed on
these 2 pins.
Jumper
PS2_USB_PW1
(see p.10, No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS Jumper
(CLRCMOS1)
(see p.10, No. 9)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3
on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right
after you update the BIOS. If you need to clear the CMOS when you just finish
updating the BIOS, you must boot up the system first, and then shut it down
before you do the clear-CMOS action.
Setting
1_2 2_3
+5V
+5VSB
1_2 2_3
Default Clear CMOS
1 7 1 7 1 7 1 7 1 7
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.