iSolution IL-0824 Operation Manual page 6

19. Speed ( Wait time )
20. Fine
21. Override
22. Button(1-24)
23. Stand alone
24. Program Mode
2. To set the tilt position of the Scanners when programming
or to set the tilt movement range for Movement function
or to set DMX value 0~255 for channels of Shutter/Gobo/
Color/Rotation/Dimmer/Focus.
Controls with two different functions:
1. To set chase speed ( wait time between scenes ) within
the range of 0.1 second to 5 minutes when running light
shows. The fade time of scenes will be always completed,
Speed slider decides the wait time ( interval time )
between scenes.
2. To set the pan position of the Scanners or to set pan
movement range for Movement function when
programming.
To control the pan or tilt movement of the fixture in the
smallest increments. Push down the joystick to active Fine
function, push again to disable the function.
To override the fixture/ fixtures when the show is running.
a.) Set DMX value 0~255 for channels of Shutter/Gobo/
Color/Rotation/Dimmer/Focus, or b.) save 24 memories
into the buttons.
2 extra easy controllers Incorporated for Master/Slave
immediate pre-programmed light shows.
Activate Program mode by pressing Blackout/Stand Alone
button. When the LED above the button is off, it's in Program
mode.
on - 5D -