CipherLab RK26 Reference Manual page 7

Important Notices
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
RF Exposure warning
This device meets the government's requirements for exposure to radio waves. This device
is designed and manufactured not to exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Communications Commission of the U.S.
Government.
The exposure standard employs a unit of measurement known as the Specific Absorption
Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using
standard operating positions accepted by the FCC with the EUT transmitting at the specified
power level in different channels.
The FCC has granted an Equipment Authorization for this device with all reported SAR levels
evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this
device is on file with the FCC and can be found under the Display Grant section of
https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm after searching on FCC ID:
Q3N-RK26.
Canada (ISED):

This Class B digital apparatus complies with Canadian ICES‐003. CAN ICES-003
(B)/NMB-003(B)
Cet appareil numérique de la classe B est conforme à la norme NMB‐0 0 3 d u Ca n a d a .
This device complies with ISED's licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d' ISED applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne
doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage
reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
(i) the device for operation in the band 5150‐5 2 5 0 M H z is on ly for in d oo r u se to red u ce th e
potential for harmful interference to co‐ch a n n el m ob ile sa tellite sy stem s;
(ii) the maximum antenna gain permitted for devices in the bands 5250‐5 3 5 0 M H z a n d
5470‐5 7 2 5 M H z sh a ll com p ly w ith th e e. i. r. p . lim it; a n d
(iii) the maximum antenna gain permitted for devices in the band 5725‐5 8 2 5 M H z sh a ll
comply with the e.i.r.p. limits specified for point‐to‐p oin t a n d n on p oin t‐to‐p oin t op era tion
as appropriate. High‐p ow er ra d a rs a re a lloca ted a s p rim a ry u se rs ( i. e. p riority u sers) o f th e
bands 5250‐5 3 5 0 M H z a n d 5 6 5 0 ‐5 8 5 0 M H z a n d th a t th ese ra d a rs cou ld ca u se in terferen ce
and/or damage to LE‐LAN devices.
Les utilisateurs devraient aussi être avisés que
3