ASROCK A770CROSSFIRE - V1.0 User Manual page 49

BIOS SETUP UTILITY
Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Enhanced Halt State
L3 Cache Allocation
Processor Maximum Frequency
North Bridge Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Target Frequency
North Bridge Target Frequency
Memory Clock
Flexibility Option
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for system stability, it is not recommended to adjust the value of this item.
Processor Voltage
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for safety and system stability, it is not recommended to adjust the value of
this item.
Processor Target Frequency
This option appears only when you adopt Phenom CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden.
The range of the value depends on the CPU you adopt on this motherboard.
However, for system stability, it is not recommended to adjust the value of this
item.
North Bridge Target Frequency
This option appears only when you adopt Phenom CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden.
The range of the value depends on the CPU you adopt on this motherboard.
However, for safety and system stability, it is not recommended to adjust the
value of this item.
CPU Frequency Multiplier
This option appears only when you adopt Phenom CPU. However, for safety
and system stability, it is not recommended to adjust the value of this item.
CPU Frequency Divider
This option appears only when you adopt Phenom CPU. However, for safety
and system stability, it is not recommended to adjust the value of this item.
If AUTO, multiplier and
voltage will be left at the
[Auto]
rated frequency/voltage. If
[200]
Manual, multiplier and
[100]
voltage will be set based
[Auto]
on User Selection in Setup.
[Enabled]
[Auto]
[Disabled]
[BSP Only]
2300 MHZ
Select Screen Select Screen
18 00 MHz
1.2500 V Select Item Select Item
[Manual]
+- +- Change Option Change Option
2300 MHz
F1 F1 General Help General Help
1800 MHz
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
[Auto]
ESC ESC Exit Exit
[Disabled]
4 9 4 9 4 9 4 9 4 9