ASROCK 939A785GMH128 User Manual page 41

BIOS SETUP UTILITY
Main OC Tweaker Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Spread Spectrum
Processor Maximum Multiplier
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Multiplier
Processor Voltage
HT Bus Speed
HT Bus Width
CPU Thermal Throttle
Memory Configuration
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Processor Multiplier
This item will show when "Multiplier/Voltage Change" is set to [Manual];
otherwise, it will be hidden. The range of the value depends on the CPU
you adopt on this motherboard. However, for system stability, it is not
recommended to adjust the value of this item.
Processor Voltage
This item will show when "Multiplier/Voltage Change" is set to [Manual];
otherwise, it will be hidden. The range of the value depends on the CPU
you adopt on this motherboard. However, for safety and system stability,
it is not recommended to adjust the value of this item.
HT Bus Speed
This feature allows you selecting Hyper-Transport bus speed. Configura-
tion options: [Auto], [200 MHz], [400 MHz], [600 MHz], [800 MHz] and
[1000 MHz].
HT Bus Width
This feature allows you selecting Hyper-Transport bus width. Configura-
tion options: [Auto], [8 Bit] and [16 Bit].
CPU Thermal Throttle
Use this item to enable CPU internal thermal control mechanism to keep the
CPU from overheated. Configuration options: [Disabled], [Auto], [12.5%],
[25%], [37.5%], [50%], [62.5%], [75%] and [87.5%]. The default value is
[Auto].
Memory Configuration
Memory Clock
This item can be set by the code using [Auto]. You can set one of the
standard values as listed: [133MHz (DDR266)], [166MHz (DDR333)] and
[200MHz (DDR400)].
H/W Monitor Boot Security Exit
Overclocking may cause
damage to your CPU and
[Auto]
motherboard.
[200]
It should be done at
[100]
your own risk and
[Auto]
expense.
x12 2400 MHZ
1.400 V
[Manual]
[x12 2400 MHz]
Select Screen
[1.350 V]
Select Item
Enter Go to Sub Screen
[Auto]
F1 General Help
[Auto]
F9 Load Defaults
[Auto]
F10 Save and Exit
ESC Exit
4 1 4 1 4 1 4 1 4 1