Adapting model dt to factory built and masonry chimneys (4 pages)
Summary of Contents for Selkirk PL
Page 1
CAN/ULC-S609 Homeowner: Keep these instructions and maintenance guide in a safe place for future reference. UL 641 Selkirk Canada Corporation Selkirk Corporation 950 South Service Road, Second Floor 5030 Corporate Exchange Blvd. Stoney Creek, ON L8E 6A2 Grand Rapids, MI 49512 Telephone: 888.735.5475...
Page 2
Canadian Standard CAN/ULC-S609 for Low Temperature Vents Type L (gas and oil) and type PL 11. When locating your appliance, consider the building structure (wood pellet) in which the maximum continuous flue gas outlet to ensure the vent will not interfere with any ceiling joists, roof temperatures does not exceed 570°...
CERTIFICATION LABELS 19. Most pellet burning appliances have powered exhausts and may be suitable for horizontal venting. However, a vertical vent Push vent sections will generally outperform a horizontal vent in exhausting flue gases. firmly together. For proper lock Apply 1/4” of RTV barb engagement, silicone on the male 20.
Page 4
1.6 Cut a hole in the ceiling and frame to the appropriate opening SELKIRK CANADA WILL NOT BE HELD LIABLE FOR size (see Table 1). Framing material shall be the same as that of ANY DAMAGES OR LOSSES ARISING OUT OF IMPROPER adjacent joist material.
E. The bottom of the Long Ceiling Support (LCS) must be a using an appropriate caulking compound as per the requirement minimum of 3” lower than the finished ceiling at the lowest side of local authorities. of the opening. F. Fasten the LONG CEILING SUPPORT (LCS) to the framed 1.13 Elbows may be used to offset the VENT when it becomes opening using 12 x 1.5”...
F. Less than 300 mm (12”) above grade level or any adjacent 2.4 Position the appliance in the desired location and according surface that might support snow, ice, or debris; to the appliance installation instructions. G. Within 1 m (3 ft) of a building opening (windows and doors) or air inlet of another appliance;...
5 PAINTING To prolong the life and appearance of the outer casing and other parts of Model PL Vent System located outdoors, use proper 3.4 A WALL BAND must be installed just above the TEE and painting procedure at time of installation. Remove oil and dirt at least every 1.8 m (6 feet) of VENT rise.
Need help?
Do you have a question about the PL and is the answer not in the manual?
Questions and answers