Table of Contents
Advertisement
OnBoard Serial Port B: Use this to set addresses for the onboard serial port
B or disable serial port B.Configuration options: [Auto], [Disabled], [3F8 /
IRQ4 /COM1], [2F8 / IRQ3 / COM2], [3E8 / IRQ4 / COM3], [2E8 / IRQ3 / COM4].
Serial/Infrared Switch: You have to select either [Serial Port B] or
[Infrared Port] . Default Value is [Serial Port B ]
OnBoard Parallel Port: Select Parallel Port address or disable Parallel Port.
Configuration options: [Auto], [Disabled], [378], [278].
Parallel Port Mode: Set the operation mode of the parallel port. The
default value is [ECP+EPP]. If this option is set to [ECP+EPP], it will
show the EPP version in the following item, "EPP Version".
OnBoard IDE: You may enable either the primary IDE channel or the secondary
IDE channel. Or you may enable both the primary and the secondary IDE
channels by selecting [Both]. Set to [Disabled] will disable the both.
Configuration options: [Disabled], [Primary], [Secondary], [Both].
OnBoard LAN: This allows you to enable or disable the "OnBoard LAN" feature.
OnBoard AC'97 Audio: Select [Disabled], [Auto] or [Enabled] for the onboard
AC'97 Audio feature.
OnBoard MC'97 Modem: Select [Auto] or [Disabled] for the onboard MC'97
Modem feature.
System Hardware Monitor: You can check the status of the hardware on your
system. It allows you to monitor the parameters for CPU temperature, Mother-
board temperature, CPU fan speed, and critical voltage.
Advanced
System Hardware Monitor
CPU Temperature
M / B
Temperature
CPU FAN Speed
Chassis
FAN Speed
Vcore
+ 3.30V
+ 5.00V
+ 12.00V
F1:Help
:Select Item
Esc:Previous Menu
2 6
2 6
2 6
2 6
2 6
AMIBIOS SETUP UTILITY - VERSION 3.31a
35 C / 95 F
27 C / 82 F
3110 RPM
N/A
1.72 V
3.31 V
4.97 V
12.16 V
+/-:Change Values
Enter:Select
Sub-Menu
[ Setup Help ]
F9:Setup Defaults
F10:Save & Exit
Advertisement
Table of Contents
