Table of Contents
Advertisement
en
Water softening system
To ensure good washing results, the
dishwasher requires soft water, i.e.
containing low amounts of lime, otherwise
white limescale will be deposited on the
utensils and inner container.
Tap water above 9° Clarke must be
softened. The water is softened with salt
(regeneration salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree of
hardness of your tap water (see table).
Setting
The amount of salt dispensed can be set
from :
to :
Salt is not required at the set value :
– Find out about the hardness value of
your tap water. Your water utility
company will help you with this.
– Set value can be found in the water
hardness table.
– Close the door.
– Switch on ON/OFF switch (.
– Press and hold down the START
button @.
– Rotate programme selector 8
until : ... is indicated on the digital
display H.
– Release button.
The factory set value :
digital display H.
To change the setting:
– Rotate programme selector 8 until
the required value is indicated on the
digital display H.
– Press START button @.
The set value is saved.
6
.
is lit on the
Water hardness table
:DWHU
+DUGQHVV
KDUGQHVV
UDQJH
YDOXH
ƒ&ODUNH
PHGLXP
PHGLXP
PHGLXP
.
PPROO
VRIW
VRIW
KDUG
KDUG
KDUG
6HW YDOXH
RQ WKH
PDFKLQH
‡ ¯¯
‡ ¯³
‡ ¯›
‡ ¯´
‡ ¯ž
‡ ¯‚
‡ ¯±
‡ ¯Å
Advertisement
Table of Contents
