Table of contents General Information .................... Information on protection of the environment ................Before using the appliance for the first time ..................Safety Instructions ....................Intended use ................................Technical safety ..............................Special information for gas cookers ......................Proper use ................................
Please Before switching on your new appliance, plea- help us by disposing of the packaging in an se read the operating instructions carefully. environmentally friendly manner. They contain important information on safety Packaging parts can be hazardous for children.
– if they are not physically or mentally and whose exhaust gases are conveyed to the capable of doing so, exterior by a flue. – or if they do not have the knowledge and experience to operate the appliance RISK OF POISONING correctly and safely.
15 minutes at maximum thermal load. Due to the effect of the heat there is a risk of burns if An intake/exhaust air wall box alone does not the surfaces of the housing are touched! ensure compliance with the limit value.
Do not flambé under the extractor hood or work with a naked flame. When switched on, the extractor hood draws flames into the filter. There is a risk of fire due to deposits on the grease filter! Do not leave pans, frying pans or deep-fat fryers unattended if you are cooking food with oils or fats, e.g.
The extractor hood can be used in exhaust air and circulating air mode. Appliance dimensions Exhaust air Exhaust-air mode The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system. Appliance dimensions Circulating air...
The light can be switched on and off independently of the fan. Light Fan settings For appliances with Intensive setting The Intensive setting generates maximum performance. It can be used if thick fumes or strong odours occur temporarily. Light Fan settings Intensive setting...
Under normal operation (daily 1 to 2 hours), or a mild window cleaner only. the metal-mesh grease filters must be cleaned – Do not scrape off dried dirt, but moisten with 1x month. a damp cloth..in the dishwasher –...
Installing and removing the activated grease filters carbon filters 1. Open the lock and fold down the grease 1. Remove the grease filters (see Removing filters. In doing so, hold the underside of the and installing the metal-mesh grease filters).
Changing the halogen bulbs Halogen bulbs become very hot during operation. Even some time after the appliance has been switched off, there is still a risk of burns! Before changing the halogen bulbs, ensure that they have cooled down fully.
Attach reducing connector directly to the air- NOTE: If long, rough exhaust air pipes, a lot of pipe connector. pipe bends or pipe diameters less than 150 mm are used, the air capacity will be less...
– Neutral situations. Brown – Live If you fit your own plug, the colours of these The extractor hood may be connected to a wires may not correspond with the identifying correctly installed earthed socket only. marks on the plug terminals.
Max. weight in kg: 50 Design subject to modification in line with technical development. 4. Drill 4x 8 Ø mm holes and press in wall plugs flush with the ceiling. 5. Attach the upper part of the support frame to the ceiling with 4 screws.
Installation Installing the lower support frame Installing the extractor hood 1. Hook the extractor hood from below into Attach upper and lower parts of the the support frame. support frame at the specified total height Do not trap the power cord! with 10 screws (preferred hole selection, see diagram).
Installation Installing the flue ducts 4. Push up the upper flue part and secure with 2 screws. RISK OF INJURY The insides of the flue ducts may have sharp edges. We recommend wearing protective gloves during installation. 1. Separate the flue ducts. To do this, remove the adhesive tape.
Need help?
Do you have a question about the I89E34N0GB and is the answer not in the manual?
Questions and answers