Related Manuals for NEFF D86M35N0GB
Summary of Contents for NEFF D86M35N0GB
- Page 1 Installation instructions and how to use and look after your built-in cooker hoods D96M6N0 / D99M6N0 NEFF (UK) Ltd...
- Page 2 Fig. 1 Abb. 1 ELECTRO mind. mind.
-
Page 3: Appliance Description
Filter grille technical measures, such as reciprocal switches interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. -
Page 4: Before Using For The First Time
Use carefully. They contain important you may find descriptions of individual information concerning your personal features that do not apply to your safety as well as on use and care of the specific appliance. appliance. This extractor hood complies with all Please retain the operating and relevant safety regulations. -
Page 5: Operating Procedure
Fan ON and appropriate intervals, the possibility of them speed increase speed catching fire as a result of a build-up of heat Intensive setting such as occurs when deep-fat frying or roasting is taking place, is reduced. Display for fan setting Switching the fan ON Cleaning the metal grease filters:... - Page 6 1. Press the catch on the grease filters (see "Removing and inserting the metal- inwards and fold the filters down. mesh grease filters"). At the same time take hold of the under- 2. Insert the activated carbon filter. side of the grease filters with your other hand.
-
Page 7: Cleaning And Care
Clean the operating buttons with a mild Caution: Refer for plug-in lampholder. soapy solution and a soft, damp cloth only. Take hold of the bulb with a clean cloth. Do not use stainless-steel cleaner to clean the operating buttons. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. -
Page 8: Installation Instructions
Only one side of the extractor hood Please ask your dealer or inquire at your may be installed next to a high-sided unit local authority about current means of or high wall. Gap at least 50 mm. -
Page 9: Prior To Installation
flue that is interlocking, etc. currently used for other purposes, nor into a shaft that is used for ventilating rooms in If the air intake is inadequate, there is a which stoves or fireplaces are also located. -
Page 10: Circulating-Air Mode
Short, smooth air exhaust pipe. Mount the pipe directly onto the air As few bends in the pipe as possible. outlet on the hood. Diameter of pipe to be as large as possible and no tight bends in pipe. -
Page 11: Electrical Connection
90 cm 20,4 20,9 regulations. If possible, site the earthed socket directly We reserve the right to construction changes within the behind the chimney panelling. context of technical development. The earthed socket should be connected via its own circuit. If the earthed socket is no longer... -
Page 12: Installation
4. Drill 4 x l 8 mm holes for the extractor hood and 2 x l 8 mm holes for the chimney panelling. Insert plugs into the holes so that they are flush with the wall. - Page 13 07. Screw in lower screws (hex screws). 11. Remove the protective film from the two flue ducts. 08. Stick protective film over the holes of the 2 lower mounting bolts in the Take care not to damage the protective grid.
- Page 14 Notes...
- Page 15 Z 5116X5 360732...
- Page 16 NEFF (UK) Ltd. Grand Union House, Old Wolverton Road, Old Wolverton Milton Keynes, MK12 5PT Tel: 01908 328300 9000 136 100 Fax: 01908 328399 Printed in Germany 0206 Es.