Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for NEFF D76S45N0GB
Summary of Contents for NEFF D76S45N0GB
- Page 1 [en] Instructions for installation and use ...2 Extractor hood...
-
Page 2: Table Of Contents
Table of contents [ en ] Ins t r u c t i o n s f o r i n s t a l l a t i o n a n d u s e INSTRUCTION MANUAL ............2 INSTALLATION INSTRUCTIONS .......... - Page 3 (e.g. wood or coal) unless a closed, non-removable Risk of injury! cover is available. due to LED lights of risk group 1. Do not look directly into the Caution! switched on LED lights for longer than 100 seconds. Risk of damage from heat accumulation due to too narrow gap Cleaning and care between appliance and high-sided unit or wall.
-
Page 4: Operating Modes
Note: The exhaust air must not be conveyed into a functioning an activated carbon filter. The different options of operating smoke or exhaust gas flue or into a shaft which is used to the appliance in circulating-air mode can be found ventilate installation rooms which contain heating appliances. -
Page 5: Installing And Removing Filter
Always leave appliance to cool down before particles from the kitchen fumes. Clean the metal-mesh grease cleaning or servicing. Switch off fuse or pull out mains plug. filters under normal use (1 to 2 hours daily) approx. every three Caution! months. -
Page 6: Replacing Bulbs
(electrician) only. ã= Risk of injury! due to LED lights of risk group 1. Do not look directly into the switched on LED lights for longer than 100 seconds. Insert bulb cover. Insert mains plug or switch on fuse again. -
Page 7: Installation Instructions
Mortal danger, risk of intoxication! Due to combustion gases sucked back in. Never operate the appliance in the exhaust air mode at the same time as a room air-dependent heat-producing appliance unless an adequate supply of fresh air is ensured. -
Page 8: Installation
The device achieves its optimum performance by means of a ■ short, straight exhaust air pipe and as large a pipe diameter as possible. As a result of long rough exhaust air pipes, many pipe bends ■ or diameters, the optimum extraction performance is not PP achieved and fan noise is increased. - Page 9 ¯ & Attaching and aligning the appliance Removing safety caps If the safety caps have to be removed, use a flat screwdriver. Initially remove the protective foil from the back of the appliance and, following installation, remove foil completely. When attaching the appliance, ensure that it engages firmly with the brackets.
-
Page 10: Attaching Flue Duct
¨ Attach exhaust air pipe to the reducing connector. Press flue duct downwards until it engages. © Seal both joints appropriately. Screw flue duct to the sides of the fixing bracket using two Electrical connection screws. ª ã= Risk of electric shock! from damaged connection cable. - Page 11 =; =; =; =; =; =; =; =;...
- Page 12 Constructa Neff Vertriebs-GmbH Carl-Wery-Straße 34 D-81739 München *9000548223* 900730 9000548223...