Subscribe to Our Youtube Channel
Related Manuals for NEFF D76E21N0GB
Summary of Contents for NEFF D76E21N0GB
- Page 1 Installation instructions and how to use and look after your built-in cooker hoods NEFF (UK) Ltd...
- Page 2 Fig. 1 Abb. 1 ELECTRO...
-
Page 3: Table Of Contents
Table of contents General Information .................... Information on protection of the environment ................Before using the appliance for the first time ..................Safety Instructions ....................Intended use ................................Technical safety ..............................Special information for gas cookers ......................Proper use ................................ -
Page 4: General Information
Please Before switching on your new appliance, plea- help us by disposing of the packaging in an se read the operating instructions carefully. environmentally friendly manner. They contain important information on safety Packaging parts can be hazardous for children. -
Page 5: Safety Instructions
– if they are not physically or mentally and whose exhaust gases are conveyed to the capable of doing so, exterior by a flue. – or if they do not have the knowledge and experience to operate the appliance RISK OF POISONING correctly and safely. -
Page 6: Special Information For Gas Cookers
15 minutes at maximum thermal load. Due to the effect of the heat there is a risk of burns if An intake/exhaust air wall box alone does not the surfaces of the housing are touched! ensure compliance with the limit value. -
Page 7: Proper Use
Do not flambé under the extractor hood or work with a naked flame. When switched on, the extractor hood draws flames into the filter. There is a risk of fire due to deposits on the grease filter! Do not leave pans, frying pans or deep-fat fryers unattended if you are cooking food with oils or fats, e.g. -
Page 8: Operating Modes
The extractor hood can be used in exhaust air and circulating air mode. Appliance dimensions Exhaust air Exhaust-air mode The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system. Circulating-air mode... -
Page 9: Operation
The light can be switched on and off independently of the fan. Light Fan settings For appliances with Intensive setting The Intensive setting generates maximum performance. It can be used if thick fumes or strong odours occur temporarily. Light Fan settings Intensive setting... -
Page 10: Cleaning And Care
Under normal operation (daily 1 to 2 hours), or a mild window cleaner only. the metal-mesh grease filters must be cleaned – Do not scrape off dried dirt, but moisten with 1x month. a damp cloth..in the dishwasher –... -
Page 11: Removing And Installing The Grease Filters
Installing and removing the activated grease filters carbon filters 1. Open the lock and fold down the grease 1. Remove the grease filters (see Removing filters. In doing so, hold the underside of the and installing the metal-mesh grease filters). -
Page 12: Changing The Bulbs
Changing the halogen bulbs Halogen bulbs become very hot during operation. Even some time after the appliance has been switched off, there is still a risk of burns! Before changing the halogen bulbs, ensure that they have cooled down fully. -
Page 13: Installation Instructions
Attach reducing connector directly to the air- NOTE: If long, rough exhaust air pipes, a lot of pipe connector. pipe bends or pipe diameters less than 150 mm are used, the air capacity will be less... -
Page 14: Electrical Connections
– Neutral situations. Brown – Live If you fit your own plug, the colours of these The extractor hood may be connected to a wires may not correspond with the identifying correctly installed earthed socket only. marks on the plug terminals. -
Page 15: Installation
(e.g. plaster board, porous concrete, poroton bricks). Ensure that the wall has adequate load bearing capacity. Ensure that the depth of the drilled holes corresponds with the length of the screws. Ensure that the wall plugs are secure. Max. weight in kg: 40 Design subject to modification in line with technical development. -
Page 16: Installation Preparations
Attachment Installation preparations 1. Remove the protective film from the 1. Mark a centre line on the wall from the extractor hood. Attach the extractor hood, ceiling to the lower edge of the extractor align and screw tightly into place. -
Page 17: Installing The Flue Ducts
Note the position of the slots in the flue duct! – Exhaust-air mode: Slots of the inner flue duct downwards. 5. Screw the inner flue duct with 2 screws to – Circulating-air mode: Slots of the inner flue the sides of the fixing bracket. duct upwards. - Page 18 Notes...
- Page 19 Notes...
- Page 20 Notes...
- Page 21 Notes...
- Page 22 Notes...
- Page 23 Accessories Z5131X5 Z5132X5 Z5133X5...
- Page 24 NEFF (UK) Ltd. Grand Union House, Old Wolverton Road, Old Wolverton Milton Keynes, MK12 5PT Tel: 01908 328300 9000 414 350 Fax: 01908 328399 Printed in Germany 0109 Es...
Need help?
Do you have a question about the D76E21N0GB and is the answer not in the manual?
Questions and answers