Table of contents General Information .................... Information on protection of the environment ................Before using the appliance for the first time ..................Safety Instructions ....................Intended use ................................Technical safety ..............................Special information for gas cookers ......................Proper use ................................
Please Before switching on your new appliance, plea- help us by disposing of the packaging in an se read the operating instructions carefully. environmentally friendly manner. They contain important information on safety Packaging parts can be hazardous for children.
– if they are not physically or mentally and whose exhaust gases are conveyed to the capable of doing so, exterior by a flue. – or if they do not have the knowledge and experience to operate the appliance RISK OF POISONING correctly and safely.
15 minutes at maximum thermal load. Due to the effect of the heat there is a risk of burns if An intake/exhaust air wall box alone does not the surfaces of the housing are touched! ensure compliance with the limit value.
Do not flambé under the extractor hood or work with a naked flame. When switched on, the extractor hood draws flames into the filter. There is a risk of fire due to deposits on the grease filter! Do not leave pans, frying pans or deep-fat fryers unattended if you are cooking food with oils or fats, e.g.
The extractor hood can be used in exhaust air and circulating air mode. Appliance dimensions Exhaust air Exhaust-air mode The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system. Circulating-air mode...
The description of the operation applies to blower when you start cooking and not to several appliance models. It is possible that switch it off again until several minutes after you individual features are described which do not have finished cooking. In this way the kitchen apply to your appliance.
Under normal operation (daily 1 to 2 hours), or a mild window cleaner only. the metal-mesh grease filters must be cleaned – Do not scrape off dried dirt, but moisten with 1x month. a damp cloth..in the dishwasher –...
Installing and removing the activated grease filters carbon filters 1. Open the lock and fold down the grease 1. Remove the grease filters (see Removing filters. In doing so, hold the underside of the and installing the metal-mesh grease filters).
Changing the halogen bulbs Halogen bulbs become very hot during operation. Even some time after the appliance has been switched off, there is still a risk of burns! Before changing the halogen bulbs, ensure that they have cooled down fully.
Attach reducing connector directly to the air- NOTE: If long, rough exhaust air pipes, a lot of pipe connector. pipe bends or pipe diameters less than 150 mm are used, the air capacity will be less...
– Neutral situations. Brown – Live If you fit your own plug, the colours of these The extractor hood may be connected to a wires may not correspond with the identifying correctly installed earthed socket only. marks on the plug terminals.
Installation The extractor hood is designed to be Installation preparations mounted on the wall. 1. Mark a centre line on the wall from the ceiling to the lower edge of the extractor During installation, optional accessories may hood. also require fitting.
Locking screws and locking caps 1. Mark the holes for the safety screws. Detach the extractor hood, drill holes for the safety screws and press in wall plugs flush with the wall.
Note the position of the slots in the flue duct! – Exhaust-air mode: Slots of the inner flue duct downwards. 5. Screw the inner flue duct with 2 screws to – Circulating-air mode: Slots of the inner flue the sides of the fixing bracket. duct upwards.