LEGRAND CHIEF Fit RFCUB Quick Setup Manual

Fit™ Mobile Cart
FOR INTERACTIVE DISPLAYS
Easy Five-Step Installation
Quick Setup Guide
For complete installation instructions, refer to the
Installation Manual included with this product.
This Quick Setup Guide is meant to provide only an
overview of the various installation steps.
ALWAYS read the Installation Instructions in its entirety
before beginning the Installation.
RFCUB
Tools Required for Installation
#2
3/16 x 1" hex bit (included)
[3/16"]
[1/8"]
(Included) 1/2" (12.7mm)
(Included)
Go to legrandav.com to access full Installation Manual for more details.
STEP 01
Assemble The Base
Assemble the right leg assembly (J) and left leg
assembly (N) to the crossbar (L) using two 5/16-18 x
4-1/4" screws (Q) through one crossbar end cap (K) per
leg. (See Figure 1)
(L) X 1
(K) X 1
(J) X 1
(K) X 1
(N) X 1
TOP
BOTTOM
Figure 1
STEP 03
Attach The Face Plate To The Top Column
Install the face plate assembly (A) to the upper column
(H) in one of three positions using one connector - stud
(E), one connector - no stud (F), and four 5/16-18 flange
nuts (W). (See Figure 3)
60" (1524 mm)
STUD
(A)
(E) x 1
(F) x 1
(H) x 1
(W) X 4
Mid
52" (1321 mm)
Low
44" (1118 mm)
Figure 3
STEP 02
Attach The Lower Column To The Base
Attach the lower column (G) to the crossbar (L) using
four 5/16-18 x 2-1/4" screws (R) and 5/16" washers (U).
(See Figure 2)
(Q) X 4
(G) X 1
Large hole
REAR
(U) X 4
(R) X 4
FRONT
Figure 2
STEP 04
Attach The Upper Column To The Lower Column
Attach the upper column (H) to the lower column
(G) using four 10-24 x 1/2" flat head screws (P).
(See Figure 4)
High
REAR
Large
(H) x 1
hole
5
(P) x 4
Figure 4
(G) X 1
REAR
(L) X 1
(H) x 1
REAR
FRONT
(G)