Input Adapter And Connection - KYOWA PCD-430A Instruction Manual

3-3-2 Input adapter and connection

This section describes how to wire a sensor to input adapters as follows.
Input adapter Applicable gage / Voltage Input
Specified for the full gage system
For strain gage transducer
Gage resistance: 120 to 1000 ohm
UI-10A
Voltage input
FV-1A is used
UI-30A Dedicated for voltage input
MEMO
If the measurement is unstable, it may be solved by grounding the [GND] terminal on the PCD-430A rear panel.
Connection
21
Remarks
A : + BV
B : - SIG
C : - BV
D : + SIG
E : Shield
F : + TEDS
G : - TEDS
TEDS supported
Inputting Voltage
B : - (L)
D : + (H)
Not compatible
with TEDS.
Not compatible
with TEDS.