Russell Hobbs 25200-56 - Hand Mixer Manual

Russell Hobbs 25200-56 - Hand Mixer Manual

Also See for 25200-56:

Advertisement

Russell Hobbs 25200-56 - Hand Mixer Manual

PARTS

PARTS

FITTING THE WHISKS/HOOKS

  1. Switch off (0) and unplug the mixer before fitting or removing the whisks/hooks.
  2. Turn each whisk or hook to align the pips on the shaft with the slots in the drive head, then push it into the drive head till it clicks into place.
  3. Each whisk/hook must be fitted into a specific drive head (fig. A).
    FITTING THE WHISKS/HOOKS
  4. Use both whisks or both hooks, don't mix them.

REMOVING THE WHISKS/HOOKS

  1. Switch off (0) and unplug the mixer, then shake any excess mixture into the mixing bowl.
  2. Hold both whisks/hooks, to prevent them jumping out, and press . This will eject them from the drive heads.

USING THE DEVICE

  1. Put the plug into the power socket.
  2. Press and release the button. The button light will flash
  3. Press the + button to start your mixer and increase the speed, press the - button to decrease the speed. When running the button light will stay on. Repeatedly pressing the - button will reduce the speed to zero and stop your mixer. The button light will flash.
  4. To stop your mixer quickly, press the button.

TURBO MODE

If you press and hold the + button while your mixer is running, after two seconds, it will run at its highest speed and continue to do so as long as you hold the button. Release the button and your mixer will revert to the previously set speed.

HINTS AND TIPS

  • Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer timings and slower speeds.
  • Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and higher speeds.
  • Use the whisks for beating/aerating light dough and batter.
  • Use the hooks for mixing heavier dough (e.g. bread, fruit-cake).
  • When making dough, use the mixer only for mixing the ingredients. Don't use it for kneading. You'll overload it and damage the motor.
  • If the motor starts to labour, add more liquid to the mix, if possible, or switch off and carry on by hand.

CARE AND MAINTENANCE

  1. Switch the appliance off (0) and unplug it.
  2. Clean the outside surfaces of the appliance with a damp cloth.

Wash the whisks and hooks in hot soapy water, or in the cutlery basket of your dishwasher.

IMPORTANT SAFEGUARDS

Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all packaging before use.

Follow basic safety precautions, including:
This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved.
Children must not use or play with the appliance.
Keep the appliance and cable out of reach of children.
Misuse of the appliance may cause injury.
Unplug the appliance before assembly, disassembly, or cleaning.
Don't leave the appliance unattended while plugged in.
If the cable is damaged, it must be replaced by the manufacturer, its service agent, or someone similarly qualified, to avoid hazard.

Do not use this appliance near bathtubs, showers, basins or other vessels containing water.

  • Don't use accessories or attachments other than those we supply.
  • Don't use the appliance for any purpose other than those described in these instructions.
  • Don't use the appliance if it's damaged or malfunctions.
  • Don't run the motor continuously for more than 5 minutes, it may overheat. After 5 minutes switch off for at least 5 minutes, to recover. Your mixer will automatically switch off after 5 minutes of continuous use.

HOUSEHOLD USE ONLY

www.russellhobbs.com

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Russell Hobbs 25200-56 - Hand Mixer Manual

Advertisement

Need help?

Need help?

Do you have a question about the 25200-56 and is the answer not in the manual?

Questions and answers

Table of Contents