Omron V7-IP65 Quick Start Manual page 47

Parameter
No.
n172 Frequency reference bias
lower limit (UP/DOWN
command 2)
n173 DC Injection Braking
Proportional Gain
n174 DC Injection Braking Integral
Time Constant
n175 Reducing Carrier Frequency
Selection at Low Speed
n176 Constant Copy Function
Selection
n177 Constant Read Selection
Prohibit
n178 Fault History
n179 Software Version No.
Multi-Function Inputs
Value Function
2 Reverse/Stop
3 External fault (NO)
4 External fault (NC)
5 Fault reset
6 Multi-step reference 1
7 Multi-step reference 2
8 Multi-step reference 3
10 JOG command
12 External base block (NO)
13 External base block (NC)
17 Local/Remote selection
Note: Refer to user's manual for full set value listings
EN-18
Description
(100ms)
Factory
Setting
Note: Refer to user's manual
0.0%
for complete list
1.Not initialized by constant
83
2.Upper limit of setting range and
(0.083)
25
3.Depends on inverter capacity.
0
4.When control mode selection
rdy
0
-
-
Multi-Function Outputs
Value
0
1
2
6
12
13
15
Analogue Output Functions
Value
0
1
initialization.
factory setting are doubled for
400V Class.
Refer to user's manual.
(n002) is changed, factory
setting corresponds to the
control mode. Refer to user's
manual.
Function
Fault output
Running output
Frequency agree
Overtorque being Monitored (NO)
Run mode
Inverter ready
Undervoltage in progress
Function
Output frequency
Output current