Download Print this page

AndyMark am-0098 Assembly Instructions

8” aluminum omni wheel

Advertisement

Quick Links

AndyMark 8" Aluminum Omni Wheel (am-0098)
Assembly Instructions
Parts needed to make an 8" Aluminum Omni Wheel:
Component
Black SBR Rollers
Steel Dowel Pins
Brass Omni-roller Sleeves
3
#10-32 x
/
" Button Head Phillips Screws
8
8" Outer Aluminum Omni Rings
8" Inner Aluminum Omni Plate
8" Aluminum Omni Wheel Assembly Instructions:
Step 1: Make sure all brass omni-roller sleeves are inside the black SBR rollers. Insert steel dowel pins into black
SBR rollers.
Step 2: Place one of the outer aluminum omni rings under the inner aluminum omni plate. Align the holes.
Step 3: Put the roll of tape onto table. Hold both of them together with your hands, and then center them
on top of the roll of tape. Remain holding on to them and insert the rollers as you do so.
For more information on our products, please visit us on our website, www.andymark.com.
Tools needed:
Qty. Part #
Phillips screwdriver
18
am-0049
Channellock plier
18
am-1019
36
am-0050
large roll of tape
18
am-1177
2
N/A
1
N/A
June 2012

Advertisement

loading
Need help?

Need help?

Do you have a question about the am-0098 and is the answer not in the manual?

Questions and answers

Summary of Contents for AndyMark am-0098

  • Page 1 Step 3: Put the roll of tape onto table. Hold both of them together with your hands, and then center them on top of the roll of tape. Remain holding on to them and insert the rollers as you do so. For more information on our products, please visit us on our website, www.andymark.com.
  • Page 2 Channellock plier to make the process run more smoothly. Step 6: Flip it over. Screw in and tighten the rest of the button head Phillip screws. Make sure it is as tight as shown below. For more information on our products, please visit us on our website, www.andymark.com.