AndyMark AM14U4 Battery Mount Installation

Battery Tray Parts

Component
10-32 x 0.5 SHCS
10-32 x 1.5 SHCS
1/4-20 x 0.75" Thread
Rolling Screw
10-32 Nylock Jam Nut
6-32 x 0.750 HHS
6-32 Nylock Jam Nut
500 Churro, 3.375"
Battery Strap
Lower Strut Spacer
Battery Bottom Plate
Battery C-Plate
Battery Clamp
Step 1: Place two 3.375" Churros (am-2569) between
the Bottom Plate (am-3959) and the C Plate (am-
3958). Secure the Churros to the plate with four ¼-20
x 0.750" Thread Forming Screws (am-1310). Make
sure the tabs on both plates are pointing upwards.
AM14U4 Battery Mount Installation
Robotics is a high-contact sport. It's important to keep your battery protected and
secured during the match. AndyMark recommends using this vertical mount to
securely hold the battery and conveniently mount your robot power connector.
Part Number
am-1002
am-1014
am-1310
am-1063
am-1424
am-1419
am-2569
am-3965a
am-3876
am-3959
am-3958
am-3960
QTY
8
2
4
10
2
2
2
1
2
1
1
1
Step 2: Slide the assembly over the End Plate such that
the Strap Clamp (am-3690) and Battery Strap (am-3965)
are centered between the ends of the C Plate. The C Plate
and Bottom Plate should be installed on the top and
bottom of the flanges on the End Plate, respectively.
Note: The assembly may need to be slightly flexed to fit
over the flanges on the End Plate.
Part Photo