Advertisement
RS-232C port communication condition setting
Set DIP SW5 to OFF to make the settings made in
PC Setup effective.
When using the CQM1H's built-in peripheral port, turn ON SW7.
Setting the Switches of a CPM2A
When using a CPM2A, the switches on the front panel must be set as shown below in order
to make the PLC Setup settings effective.
Setting the Switches of a CPM2C
When using a CPM2C, the switches on the front panel must be set as shown below in order
to make the PLC Setup settings effective.
Setting the Switches on a RS-232C Adapter
When using a CPM1-CIF01 RS-232C Adapter, set the mode switch as shown in the following
diagram.
Set the mode setting switch to HOST (upper position).
Set the Communications
switch to OFF (down
position).
The settings for SW1 and SW2 depend upon the usage of the peripheral
port and RS-232C port.
• Connecting PT to peripheral port
• Connecting PT to built-in RS-232C port
(A device that requires non-standard communications settings is
connected to the peripheral port.)
• Connecting PT to built-in RS-232C port
(A Programming Console is connected to the peripheral port.)
17
Advertisement
