SEGUE MOD-1362 Assembly

- Assembly
MOD-1362 - iPad Kiosk
Item Qty. Description
1/1a 1/1 32.075" TSP49 Curved SEG Extrusion
1b 1 9.07" TSP49 Curved SEG Extrusion
2/2a 1/1 32.075" TSP49 Curved SEG Extrusion
2b 1 9.07" TSP49 Curved SEG Extrusion
3 1 20" TSP49 Horizontal SEG Extrusion
4 1 20" TSP49 Horizontal SEG Extrusion
5 1 20" TSP49 Horizontal SEG Extrusion
6 1 20" TSP49 Horizontal SEG Extrusion
7 1 16.4" Z45 Horizontal Extrusion
Steps:
1) Connect [1] to [1a] and [2] to [2a].
2) Connect [1/1a] and [2/2a] with [3].
3) Slide [7] into groove.
4) Connect [1/1a] and [2/2a] with [4] and assembled lightbox.
5) Attach assembled frame to base with bolts.
6) Attach front SEG graphics.
7) Position part [7] and lock in place.
8) Attach iPad mount see detail.
-- Continued page 2 --
Graphic: To Ensure Proper Fit
Corner A Corner B
Corner D Corner C
It is important to first insert Step 1
graphic into each alternate
Insert corner A. Turn edge of
corner then to the sides of graphic so silicon welt is
the frame. If this is not done, perpendicular to face of
graphic will not fit into the graphic. Insert narrow side
frame correctly.
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
1b
TSV1
Lock
1a
1
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Graphic Removal
TSV1
Lock
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
6
2b
5
TSV1
Lock
4
7
2a
2
Bolt
3
TSV1
Lock
LED Light
strips
around
perimeter
*
Mount Attachment
Z45
Do not remove
bolts from V20's
Apply SEG graphic and position extrusion [7]
Base by loosening set screws, sliding into place, and
tightening set screws. S10 extrusion should
poke through hole in graphic. Loosen bolts on
iPad mount (Do Not Remove) and slide V20's
into S10 groove. tighten bolts to secure.
TSV1 Lock Detail
Lock
TSP49
Tighten setscrew
to secure
extrusions
S10
7
V20's
*
© 2015