Safety Directions - LiteOn AP900Ci Manual

2

SAFETY DIRECTIONS

The AP900Ci is designed to function as a Cruise Control, Speed Limiter or RPM
limiter.
The installer must have sufficient knowledge and experience with modern
vehicle-electronics.
Incorrect and/or substandard installation, connection, adjustments and/or
diagnostics of the vehicle and/or Cruise Control may indirectly affect road
safety.
Never change or manipulate an AP900Ci. Changes or technical manipulations to the
product may adversely affect its safety and lead to the expiry of the warranty period.
Connections made without connectors should be soldered properly. DO NOT
USE SCOTCH LOCKS! Isolate the connection preferably carefully with
high-quality insulation tape.
Always install the electronic module in a place where heat, vibration and
moisture are kept to a minimum, for example under the dashboard.
Always remove the negative clamp from the battery before working on the vehicle.
Loss of volatile data is possible (radio, on-board computer, clock, etc.) .
Always use a digital multimeter for measurements. Do not use a test-light or
LED-circuit-tester. This can lead to damage to the microelectronics in the
vehicle.
Cut wires without connectors to size and avoid unnecessary lengths. Finish the
cabling neatly with cable bundle tape after all connections have been made.
The CAN-bus wires are twisted in pairs to ensure reliable operation. After
connecting to the CAN-bus wires (blue twisted with blue and white) the not twisted
length may be not more then 5cm.
Because the AP900Ci is programmed for the vehicle model, it is not necessary to
calibrate the speed signal.
5