Curtis RCD856 Instruction Manual page 9

HIGH SPEED MUSIC SEARCH
During CD playback you may search forward or back within the tracks of the disc to locate a
specific musical passage if desired. To perform high speed music search press and hold either the
SKIP FORWARD or SKIP BACK buttons. Release the buttons when you locate the desired
passage and normal playback will resume at high speed music search.
REPEAT PLAY MODES
There are 3 repeat options for your convenience. Pressing the REPEAT button will cycle the
changer through the three modes as follows:
1st Press Repeat All Tracks On All Discs In The Tray
2nd Press Repeat All Tracks On One Disc
3rd Press Repeat One Track
4th Press Repeat Mode Off Normal Playback Resumes
PROGRAMMED PLAYBACK
The CD changer has a 32 track programmable memory that allows you to program up to a total of
32 tracks on 3 discs for playback in any order you choose. You may also program a specific track to
be played more than once in a program sequence.
TO PERFORM PROGRAMMED PLAYBACK PROCEED AS FOLLOWS:
1 Open the CD door and insert up to 3 discs in the tray, then close the door.
2 At stop mode Press the PROGRAM button once. The display will show the 01 d1
indicates that the memory is ready to accept the first disc and track to be programmed.
3 Select the first disc you wish to program by pressing DISC SKIP. For example, DISC2.the disc
number will appear on the display as 01 d2 -- --.
4 Select the first track you wish to program by pressing SKIP FORWARD button until the desired
track appears in the display, EDIT indicator will appear and flash. For example, TRACK7.The
display will show 01 d2 07.
5 When the display correctly shows the first disc and track number you wish to program, press the
PROGRAM button again to enter the track number in the memory.Display will now appear as
02 d2: -- --. This indicates that the memory is ready to accept the second track to be
programmed. The EDIT indicator stop flashing.
6 Repeat steps 3,4 and 5 until you have entered up to 32 tracks into the memory.
7 When you finish programming press the PLAY/PAUSE button to begin programmed playback.
The PROGRAM indicator appears in the display and the changer will play back the tracks and
discs in the order in which you entered them into the in program memory.
NOTES:
-- --. This