Page 3
Important Important For expert advice, please phone the ASDA helpline on 0 8 4 5 3 0 0 7 7 7 5 0 8 4 5 3 0 0 7 7 7 5 As supplied Folded to form a stand Folded for wall mounting...
TO Prevent fire or shock hazard, do not use this plug with an extension cord, receptacle or add other outlet unless the blades can be can be fully inserted to prevent blade exposure. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. RISK OF ELECTRICSHOCK RISK OF ELECTRICSHOCK The lightning flash with arro-...
Quick View To get the maximum enjoyment and performance from this product, please read this manual and familiarize yourself with the functions and controls before attempting to operate it. Correct usage will assure years of trouble free performance and listening pleasure. Front View Rear View FM Antenna...
Getting Started Unpacking your RCD869 Micro System Carefully remove your CD micro system from its packaging. You may wish to store the packaging for future use. Box Contents: • CD micro system • 2 speakers (speaker cables attached) • Remote control •...
Page 8
Remote Control The remote control requires 1 x 3V Lithium Battery, (CR2025). Battery Installation 1. Press the small clip down a little as shown in the first picture then slide the battery holder out and remove. 2. Refer to polarity (+ or -) markings on the battery holder and insert a new battery.
Setting the Clock The clock can be set by using the buttons on the front of the unit or the remote control. Setting the Clock using the Unit Controls 1. Press STANDBY on the unit so that the display on the unit dims and the clock is displayed.
Operation Now your CD micro system is installed and ready for use, please refer to the following instructions for correct operation. AC Power Operation The CD micro system will be in standby mode, when the AC power supply is connected and switched on.
Page 11
Radio Operation At the front of the CD micro system, or using the remote control, press STANDBY, to switch the CD micro system on. The LCD display will light up. Press either the FUNCTION button on the remote control or the TUNER button on the unit to select the radio tuner.
Page 12
Preset Memory Stations Your CD micro system can store up to 20 preset radio stations, 10 FM and 10 AM. Once a station is in a preset memory it can be retuned by pressing the M-UP/REPEAT button on either the remote control or the front of the unit until the desired preset number is displayed.
CD player Operation At the front of the CD micro system, or using the remote control, press STANDBY, to switch the CD micro system on. The LCD display will light up. Set the function switch to CD. The display will initially flash zeros then show ‘no dISC’.
Programmed Playback Up to 20 tracks can be programmed for playback. Using the remote control: 1. Press the PROG,/MEMORY button. MEMORY will flash on the display, the track number is shown on the left and the program number on the right, as below.
Page 15
Timer Setting the timer 1.Press the TIMER button to turn the timer function on,TIMER will flash on and off for a short time. 2.While timer is flashing on the display, hold the PROG/MEMORY button down for 3 seconds and then release.The display will show the time with the hours flashing on and off.
Care and Maintenance Compact Disc Care CD Handling When handling CDs: • Do not touch the recorded surface. • Do not stick paper, or write, on either side of the CD. • Do not bend the CD. CD Storage • To avoid scratches/damage, always put CDs back in their cases, after use.
Specification POWER SUPPLY 120V ~ 60Hz UNIT DIMENSION (mm) 140 (W) x 165 (H) x 245 (D) SPEAKER DIMENSION (mm) 130 (W) x 155 (H) x 195 (D) Radio FREQUENCY RANGE 87.5 - 108MHz 520 - 1710kHz Laser OPTICAL PICKUP Class 1 Laser Note: Specification subject to change without notice.