Remote Control - Curtis RCD-718 Instruction Manual

1 Standby/On Button
2 Random Button
3 Intro Button
Sleep Button
4
5 Volume+ Button
Stop Button
6
7 Track/Tune Forward Button
8 Mute Button
9 M-Up/Repeat Button
INSTALLATION BATTERY
The remote control use 1 power source, CELL BATTERY (CR 2025, 3V).
Simply pull out the insulation tag in the battery compartment. The remote control is now funct-
ional.
Be sure to observe the polarity makings which are engraved inside the battery compartment,
thenclose the cover.
BATTERY REPLACEMENT
When the batteries become too weak, the operating distance of the remote controller is greatly
reduced and you will need to replace the batteries.
Open the battery compartment cover, use a screwdriver or other tool to push out the battery
(follow the exit direction in pushing out). Push in the new battery in the opposite direction (the
+polarity is faced up.) Put the cover back and secure.
Note:
To maintain the accuracy and long life of the transmitter, do not press two or more buttons si-
multaneously.
If the remote control is not used for a long time, remove the batteries to prevent possible dam-
age through leaking batteries.
Do not mix different types of batteries, or old batteries with new ones.
USING THE REMOTE CONTROLLER CORRECTLY
Point the remote controller at the Remote Sensor.
The functions of the buttons on the remote control are the same as the corresponding controls
on the main unit.
When there is a strong ambient light source, the performance of the infrared Remote Sensor
may be degraded, causing unreliable operation.
The maximum effective distance for remote control operation is about 15 feet.

REMOTE CONTROL

Memory/Program Button
10
Preset EQ Button
11
12 Track/Tune REW Button
13 Play/Pause Button
14 Volume- Button
15 Timer Button
16 Display Button
17 Function Button
1
17 2
16
3
15
4
14 5
13
6
7
12
8
11
9
10