Remote Control - Curtis RCD725C Instruction Manual

1 Functiceon Button
2 Standby/On Button
3 Timer Button
4 Sleep Button
5 Stop/Band Button
6 Random Button
7 Play/Pause Button
8 Track/Tune Forward Button
9 M-Up/Repeat Button
INSTALLATION BATTERY
The remote control uses 1 power source, CELL BATTERY (CR 2025, 3V).
Simply pull out the insulation tag in the battery compartment. The remote control is now functional.
Be sure to observe the polarity makings which are engraved inside the battery compartment, then close
the cover.
BATTERY REPLACEMENT
When the battery become too weak, the operating distance of the remote controller is greatly reduced
and you will need to replace the battery
Open the battery compartment cover, use a screwdriver or other tool to push out the battery (follow the
exit direction in pushing out). Push in the new battery in the opposite direction (the+polarity is faced up.)
Put the cover back and secure.
Note:
To maintain the accuracy and long life of the transmitter,do not press two or more buttons simultaneously.
If the remote control is not used for a long time, remove the battery to prevent possible damage through
leaking battery.
USING THE REMOTE CONTROLLER CORRECTLY
Point the remote controller at the Remote Sensor.
The functions of the buttons on the remote control are the same as the corresponding controls on the
main unit.
When there is a strong ambient light source, the performance of the infrared Remote Sensor may be
degraded, causing unreliable operation.
The maximum effective distance for remote control operation is about 15 feet.

REMOTE CONTROL

10 Program/Memory Button
11 Volume+ Button
12 Mute Button
13 Volume- Button
14 Preset EQ Button
15 Track/Tune REW Button
16 Intro Button
17 Display Button
1 2
3
4
17
5
6
16
7
15
8
9
10
14
11
13 12