RITZ RTZSA09 User Instruction Manual

WARNING: User must understand the manufacturer's instructions and be trained in the proper use of e. Manufacturer's
instructions must be followed for proper installation, use, care, and maintenance of this product. These instructions must
always be available for reference. Alterations or misuse of this product or failure to follow instructions may result in
serious injury or death.
IMPORTANT: This manual is intended to meet the Manufacturer's Instructions as required by the American National
Standards Institute (ANSI) Z359.18-2017 and should be used as part of an employee training program as required by
the Occupational Safety and Health Administration (OSHA). All components or subsystems used with the beam anchor
discussed in this manual must be in compliance with ANSI Z359 and OSHA.
1.0 WARNINGS REGARDING THE BEAM ANCHOR:
•
Before use, all users must understand the instructions, operation, limitations, and consequences of improper use of
device.
•
Before use, all users must be properly trained in accordance with the requirements of OSHA 29 CFR 1910.66 and
1926.503 or applicable local standards in the safe use of the fall arrest system and its components.
•
Before use, thoroughly inspect the beam anchor as indicated in Section 8.
•
Only use the N-800 beam anchor with ANSI/OSHA compliant personal fall arrest or restraint systems.
•
In the absence of certification, the anchorage must be capable of supporting a static load, applied in the directions
permitted by the system, of at least 5,000-lbf (22kN).
•
The user shall be equipped with a means of limiting the maximum dynamic forces exerted on the user during the
arrest of a fall to a maximum of 8 kN (1800-lbf).
•
A competent engineer or other qualified person must approve that the use of N-800 beam anchor is compatible
with all structural and operational characteristics of the selected installation location and system that it will relate
to.
Prior to each use, the N-800 must be inspected for wear, damage, and other deterioration. The beam anchor must
•
immediately be removed from service (in accordance with OSHA 29 CFR 1910.66 and 1926.502) if it does not
pass inspection.
Before use, ensure that the complete fall protection system (including components, fall clearance, and swing fall)
•
are planned and established correctly.
•
Position the beam anchor in such a way to minimize the potential for falls, and the fall distance during use.
•
Before use, establish a rescue plan that provides either: prompt rescue of users in the event of a fall, or assures
users can rescue themselves. Also confirm that the means to implement said rescue plan are at hand and easily
accessible.
After a fall, the anchorage connector must be removed from service and destroyed immediately.
•
2.0 WARNINGS REGARDING WORKING AT HEIGHT:
•
Before use, consult your doctor to ensure that your physical condition allows you to safely withstand the impact of
all forces involved with working at height.
Do not use any fall protection equipment that has failed inspection.
•
Ensure all connections are compatible, and that all subsystem combinations do not interfere with the function of
•
this device.
Ensure that a written rescue plan, and the means to implement it, are always available when using this device.
•
For more information, refer to ANSI Z359.4-2013 and Z359.2-2017.
•
Immediately seek medical attention for the affected party if a fall event occurs.
• When inspecting, installing, or using the device / system, always ensure that you wear appropriate Personal
Protective Equipment.
•
Never exceed: maximum free fall distance and allowable capacity for your fall protection.
•
Never expose workers to fall hazards during training.
USER INSTRUCTION MANUAL:
RTZSA09 BEAM ANCHOR
1