Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for DoAll CH300
Summary of Contents for DoAll CH300
- Page 1 CLAYHAWK FULL COCK TRAP MODEL: CH300...
-
Page 2: Included Parts
INCLUDED PARTS Handle Trap Head Main Spring and Spade Bolt Pivot Mount Triangle Pivot Mount Safety Ring Arms Safety Ring Bolts and Nuts for Pivot Mount Bolts and Nuts for Frame assembly Base Frames Safety Ring Clips Upright Frames Allen Wrench Ground Stakes Allen Bolts for Safety Ring Arms... - Page 3 STEP 1 Take the Ground/Base Frame with holes and lay out in a triangular shape. Take one of the Side/Corner Upright Frames and overlap one corner of the Ground/Base triangle. Push the hex bolts (one of the 12 included) through the ground base and into the side corner upright from the inside out.
- Page 4 STEP 2 Once you have assembled the bottom and sides of the base assembly, cap with the Triangular Pivot Mount. Now that the top is in place, secure with provided hex bolts and hex nuts from the inside out. Be sure to go back and tighten down all hex nuts on frame assembly.
- Page 5 STEP 3 Take the 1 3/4" (shorter) Hex Bolt and Nut and push up through the center hole of the Triangular/Top Pivot casting securing with the 1/2" hex nut. This is where you will attach the 3 Pivot Mount.
- Page 6 STEP 4 Insert longer bolt into hexagon shaped opening, in the trap head carriage through the top of the pivot mount assembly, interlocking the gear mesh teeth. Secure with 1/2" nut using wrench.
- Page 7 STEP 5 Attach Handle to Trap Head by threading into thethrough trap head into handle. Tighten securely.
- Page 8 STEP 6 To attach safety ring, attach the ring brace arms using allen screws. Pinch arms of the safety ring clips and slide them over ends of safety ring. Push ends of ring guard over posts on trap head and slide safety ring clips down over safety ring and post to secure.
- Page 9 STEP 7 Rotate the arm counter clockwise into the 1 o'clock position. Hook the black main spring into the silver swiveling spring hook, which is attached underneath the throwing arm/clutch pivot point. At the narrow end of the black main spring, screw one of the provided 1/2"...
- Page 10 THANK YOU Ensure all hardware is tightened. Once the Main Spring is installed, the thrower is live. Please refer to operation and warnings on the next page.
-
Page 11: Operation
OPERATION 1. Position trap in desired location suitable for shooting trap. ALWAYS MAKE SURE YOU POINT THE TRAP IN A SAFE DIRECTION AWAY FROM BYSTANDERS, TREES, OR ANIMALS WITH AT LEAST A 400 METER OPEN FIELD/SHOT FALL ZONE. 2. Elevation can be adjusted by loosening the bolt in the middle of the Pivot Mount and then tightening once adjustment has been made. -
Page 12: Troubleshooting
TROUBLESHOOTING Clay pigeons only throwing a short distance - Make sure the Trap is firmly secured and wont move or bounce. Tighten the nut on the spring which will increase arm swing speed. Clay pigeons breaking during use - Clay pigeon clamp is too close to the trigger. Un-cock the machine and loosen the wing nut and slide the clamp forward on the arm.
Need help?
Do you have a question about the CH300 and is the answer not in the manual?
Questions and answers