Operation - Ego Power+ WDV0900E Operator's Manual

Connect the crevice nozzle to the vacuum hose and snap
the remote control onto the remote-control mount on the
vacuum hose. Press the light button on the remote control
and the transparent crevice nozzle will light up.
Power-Tool Adapter (Fig. D3)
The power-tool adapter allows the vacuum cleaner to
connect to a power tool with 32 mm dust outlet.
With the vacuum hose connected to the suction inlet port
of the vacuum cleaner, insert the power-tool adapter into
the vacuum cleaner as far as you can until the power-tool
adapter is secured in place and then connect the adapter to
the dust outlet of the power tool.
WARNING:
The power-tool adapter cannot be
connected to the extension tube(s). Forcing the installation
may cause damage for the power-tool adapter or the
extension tube(s).
INSTALLING/REMOVING THE POWER HEAD
ASSEMBLY
To install, push the lower parts of the dust tank latches,
lower the power head assembly onto the dust tank, and
then push the upper parts of the dust tank latches
(Fig. E1 & E2).
To remove, push the lower parts of the dust tank, and
then lift the power head assembly (Fig. E3).
INSTALLING/REMOVING THE DUST BAG
1. Unlock the dust tank and lift the power head
assembly.
2. To install, insert only the plate of the dust bag into
the slot of the dust bag bracket until the plate falls
down the ribs. Unfold the dust bag manually before
collecting dust or debris (Fig. F1).
To remove, slightly lift the plate over the ribs and
then pull the plate from the slot to remove the dust
bag (Fig. F2).

OPERATION

APPLICATION
You may use this product for the purposes listed below:
◾
Sucking in liquid waste or dry dust when the suction
inlet port is used.
◾
Functioning as a blower when the blowing outlet port
is used.
56 VOLT LITHIUM-ION CORDLESS WET/DRY VACUUM CLEANER — WDV0900E
ATTACHING/DETACHING THE BATTERY PACK
Fully charge before first use.
To attach
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a "click" (Fig. G1).
To detach
Depress the battery-release button and pull the battery
pack out (Fig. G2).
STARTING/STOPPING THE WET/ DRY VACUUM
CLEANER (FIG. H)
To Start the Vacuum Cleaner
1. Verify that power head assembly is installed onto
the dust tank and the dust tank is securely locked.
Ensure that the vacuum hose, required extension
tube(s), and nozzle are connected properly.
NOTE:
The vacuum cleaner runs only when the power
head assembly is securely attached to the dust tank.
2. Install the battery pack.
3. Press the power button to power up the vacuum
cleaner.
4. Press the speed adjustment button to select low
speed or high speed, and then press the start/stop
button to start the vacuum cleaner. Or, press the
TURBO button to start the vacuum cleaner directly at
maximum speed.
NOTE:
The speed can also be adjusted during vacuuming.
For more information refer to the chapter "SPEED
SELECTION".
To Stop the Vacuum Cleaner
1. Once the vacuuming is completed or when the dust
tank is full, press the start/stop button to stop the
vacuum cleaner temporarily.
2. Or press the power button to power down the
vacuum cleaner completely.
3. Remove the battery pack.
4. Empty the dust tank into a suitable receptacle or
drain.
NOTE:
The vacuum cleaner will resume the previously
active regular speed setting when restarting.
9