Advertisement
Quick Links
Single Side Mirror Kit
Z-Master® Series Riding Mower with Road Light Kit
Model No. 134-8275
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Mirror with clamp
Mirror arm assembly
Mirror bracket (7500)
Mirror bracket (4000)
Flange-head bolt (M6–16)
Flange-head bolt (M6–20)
Washer
Flange-head bolt (M6–16, 2000 only)
Flange-head bolt (M6–20, 2000 only)
Washer
Flange-head bolt (M10, 4000 only)
Flange-head nut (M10, 4000 only)
Carriage bolt (7500 only)
Locknut (7500 only)
Preparing the Machine
1.
Park the machine on a level surface.
2.
Move the motion-control levers to the N
3.
Engage the parking brake.
4.
Shut off the engine and remove the key.
© 2022—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Qty.
–
Prepare the machine.
1
1
1
1
Assemble the mirror.
1
1
1
1
1
4
2
Assemble the mirror to the machine.
2
2
2
-L
EUTRAL
OCK
Figure 1
Register at www.Toro.com.
Use
position.
Original Instructions (EN)
Printed in the UK
All Rights Reserved
Form No. 3459-719 Rev A
Installation Instructions
*3459-719*
g037289
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Toro Z-Master 134-8275
Summary of Contents for Toro Z-Master 134-8275
- Page 1 EUTRAL Engage the parking brake. Shut off the engine and remove the key. g037289 Figure 1 *3459-719* © 2022—The Toro® Company Original Instructions (EN) Register at www.Toro.com. 8111 Lyndale Avenue South Printed in the UK Bloomington, MN 55420 All Rights Reserved...
- Page 2 Assembling the Mirror All models: Loosen the 2 socket-head bolts that secure the halves of the mirror clamp (Figure Z-Master 4000 and 7500 only: Align the holes in the mirror bracket with the holes in the mirror arm as shown in Figure Secure the mirror bracket to the mirror arm assembly with a flange-head bolt (M6–20), a...
- Page 3 Assembling the Mirror to the Machine Z-Master 2000: Note: Kit can be installed on either side of the machine. Determine the left and right sides of the machine from the normal operating position. Secure the mirror bracket to the frame using 1 flange-head bolt (M6–16), 1 flange-head bolt (M6–20), and 2 washers.
- Page 4 Note: Secure the mirror bracket and horn assembly to Place the washers to the outside of the spacer the frame using flange-head bolts (M10) and 2 as shown in Figure flange-head nuts (M10). Z-Master 7500 (72 inch) Note: Kit can be installed on either side of the machine.
Need help?
Do you have a question about the Z-Master 134-8275 and is the answer not in the manual?
Questions and answers