Arkon HD8RV29 Instructions

HD8RV29 | Arkon Pro Stand for Phones, Cameras, or Pico Projectors
Your Pro Stand will arrive in five pieces:
SPHD8BASE
Weighted Base
with Allen Wrench
SPHD8L29
Telescoping Pole
Insert pole into base.
1
Tighten clockwise
to secure.
Telescoping Telescoping
Pole
Unscrew tightening ring from holder. Place ring over the 17mm end of
3
mount then snap the holder onto the ball. Set to desired position, then
tighten ring.
Tightening Ring Tightening Ring
MG005WR
Phone Holder Phone Holder
SP3RMPR0PL SP3RMPR0PL
Overhead Arm
Assembly
SP25MMCAM
25mm to 1/4"-20
Camera Bolt Adapter
(optional)
Allen Allen
Wrench
SP3RMPROPL
MG005WR
SPHD8L29
SPHD8BASE
Assembled Mount
Attach overhead arm assembly by unscrewing the collar at the top of Attach overhead arm assembly by unscrewing the collar at the top of
2
the pole until the metal ball side of the overhead arm assembly fits the pole until the metal ball side of the overhead arm assembly fits
into the collar. Tighten collar clockwise to secure. into the collar. Tighten collar clockwise to secure.
Using two hands, insert phone into the holder by pushing the device
4
into one of the spring-loaded support arms. Expand the other support
arm and fully insert device.
rev.021022
Telescoping pole extends upward from
17 inches to 29 inches.
Compatibility:
Fits smartphones with cases weighing
up to 2 pounds and measuring up to
3.9" wide.
IMPORTANT:
Do not overtighten ring. Overtightening
ring may damage threads on holder
and also make it difficult to adjust
holder.
Metal
Ball side Ball side
Collar
Tightening
Knob
Continued on page 2