Fresh Water - Airstream INTERNATIONAL CCD Owner's Manual

ELECTRICAL SYSTEM
MICROPULSE SYSTEMS MONITOR OPERATION
INSTRUCTIONS
This example shows the monitor reporting the
following:
Fresh Water = 7/8 to Full
Gray Water 1 = Empty to 5/8
Gray Water 2 = 3/4
Black Water = Empty to 5/8
Battery = Empty to 5/8
On all diagrams the Letters R=Red, Y=Yellow,
G=Green, Blank=no LED lit.
G
Monitor Display

Fresh Water

R
Gray Water 1
G
Gray Water 2
Y
G Black Water
G Battery
NORMAL OPERATION
The MicroPulse Monitor will display the condition of
each system at all times. The tri-color LED beside the
system will indicate the condition of the system using
the following color code.
Fresh Water and Battery are as follows:
Green LED = 3/8 to Full
Yellow LED = 1/4
Red LED = 1/8 to Empty
Gray Water, Black Water are as follows:
Green LED = Empty to 5/8
Yellow LED = 3/4
Red LED = 7/8 to Full
NOTE: The steel LP tanks on the International Trailer
Models do have a level sensor. The monitor system
does not read LP Gas levels.
G - 11
TO OBTAIN EXACT READING
To obtain an exact reading of all systems press and
release the status button one time. The monitor will
flash the LED beside the system it is about to report. It
will than display the exact condition of that system by
lighting the bar graph from Empty to Full. The monitor
will display the exact condition of each system and
then return to normal operation mode.
To obtain an exact reading of an individual system
press and release the status button until the LED
beside the system that you want the condition of is lit.
Release the status button and the monitor will display
the exact condition of that system by lighting the bar
graph from Empty.