Airstream INTERNATIONAL CCD Owner's Manual page 83

SATELLITE ANTENNA WIRING
(Not available on the 16 ft. model.)
If you compare the two drawings you'll see wiring for a satellite dish antenna
is relatively simple.
Units have a faceplate with two coax cable hook-ups. It is located as fol-
lows:
19 ft. model: on the roadside bedroom wall.
22 ft. model: above the desk.
25 ft. sleep six and 27 ft front bed models: roadside wall forward of the re-
frigerator.
23 ft, 25 ft. front bed and 28 ft. models: under the dinette table.
The faceplate has a small coax cable jumper running between the hook-ups
to complete the cable TV circuit when in use.
To install a satellite system use the following procedure:
1. Remove the jumper wire from the coax faceplate.
2. Hook a portable dish into the exterior Cable TV receptacle. This feeds the
dish signal to the input side of the faceplate.
3. Install the satellite receiver input and output into the dual coax faceplate.
To return to a Cable TV system, remove the satellite receiver from the face-
plate and reinstall the jumper cable.
ELECTRICAL SYSTEM
COAXIAL CABLE WITH CABLE HOOK UP
Antenna Lead in
TV
Jumper
Cable
Exterior Cable TV Hook Up
COAXIAL CABLE WITH SATELLITE HOOK UP
Antenna Lead in
TV
Satellite
Reciever
Exterior Cable TV Hook Up
Satellite Antenna
G - 8
TV Antenna
Front TV Jack
W/Booster
TV
Dual Coax
Faceplate
TV Antenna
Front TV Jack
W/Booster
TV
Dual Coax
Faceplate
G