Table of Contents
Advertisement
The lock mode icon
of the transmitter or the lock mode icon
flashes prior to the lock mode being activated again.
B.Ch: 1. 1
ew300IEM
519.150
MHz
EQ
Standard -18dB
Adjusting the audio channels on the transmitter
Via the "Mode" menu item, you can adjust the audio channels.
Select "Stereo" if you want to transmit two separate audio signals on channel I and
channel II (e.g. channel I = audio signal of the presenter/musician, channel II = sum of all
audio signals). Make sure that the receiver's pilot tone evaluation
item) is activated.
This allows the presenter/musician to adjust the balance between the left and right stereo
signal on his receiver.
Select "Mono" if you only want to transmit a mono audio signal. In this case, the signal
from the left audio input
During mono operation, you have to deactivate the pilot tone evaluation on the
diversity receiver
outputs the same signal on channel I and II.
Activating/deactivating the RF signal on the transmitter
To
deactivate
the RF signal:
When the standard display is shown on the display panel, press the
button.
"RF Mute
On?" appears on the display panel.
Press the jog dial.
The RF signal is deactivated. The transmission icon
addition, the display backlighting changes from orange to red and
flashes in alternation with the standard display.
To
activate
the RF signal:
Press the
STANDBY
"RF Mute
Off?" appears on the display panel.
Press the jog dial.
The RF signal is activated and the display backlighting changes from red to
orange.
You can also deactivate the RF signal on switch-on. For more information, refer to
the chapter "Switching the devices on/off" on page 16".
BAL AF IN L
is transmitted.
("Pilot
Tone" menu item) in order to ensure that your receiver
button.
Using the devices
of the diversity receiver
519.150
MHz
ew300 IEM
MUTE
P
RF
AF
("Pilot
Tone" menu
STANDBY
is not displayed. In
"RF
Mute"
19
Advertisement
Table of Contents
