Using The Twin Receiver; Switching The Twin Receiver On/Off; Connecting The Headphones/Adjusting The Volume; Activating/Deactivating The Lock Mode - Sennheiser EM 550 G2 - 02-06 Instructions For Use Manual

14

Using the twin receiver

Switching the twin receiver on/off

Each receiver of the EM 550 G2 is switched on and off separately with the
button. The receivers can only be switched off when the standard display is
shown on the display panel. When in the operating menu, briefly pressing the
ON button will cancel your entry (ESC function) and return you to the
standard display with the last stored settings.
Press the ON button
To switch the receiver off, press the
display.
After switch-off, the receiver is in standby mode. To disconnect the receiver
from the mains, pull out the mains connector.

Connecting the headphones/adjusting the volume

Each receiver of the EM 550 G2 has its own separate headphone output
monitoring the audio signal.
Connect headphones with a ¼" (6.3 mm) jack plug to the headphone
output (PHONES) .
Attention! High volume!
Even short exposure to high volume levels will damage your hearing!
Set the volume for the connected headphones to the minimum before
putting the headphones on.
First, set the volume control
left as far as possible. Then gradually turn up the volume.
Volume up? – NO!
When people use headphones, they tend to choose a higher volume than
with loudspeakers. Listening at high volume levels for long periods can
lead to permanent hearing defects. Please protect your hearing,
Sennheiser headphones have an excellent sound quality even at low
volumes.

Activating/deactivating the lock mode

Each receiver of the EM 550 G2 has a lock mode that can be activated or
deactivated via the operating menu (see "Activating/deactivating the lock
mode" on page 25). The lock mode prevents that the receiver is accidentally
programmed or switched off during operation.
to switch the receiver on.
ON button until "OFF" appears on the
to the lowest volume by turning it to the
ON
for