Stand-By - Sennheiser EM 203 Instructions For Use Manual

MANIPULATION
Depress the stand-by
key
and choose
or
Depress the stand-by
key once again to put
the unit to work
and choose
EM 203, Publ. 10/94 engl

Stand-by

FUNCTION
In some situations it is useful not only to
mute the audio signal at the mixing console
but also to switch off the complete RF section
of the EM 1046 receiver module.
Two reasons of several possible are:
•
•
The receiver offers two options:
Y = yes, switch off receiver
N = no, return to normal operation
Y
N
If the receiver has been switched off, the
display indicates for about 2 seconds
and subsequently goes out, except for a small
luninous spot.
Y =
N =
Y
N
NOTA BENE
Depressing the menu keys during stand-by
operation results in the indication of the
receiver frequency selected (see ch. 4.1.2).
The monitor key remains active!
DIVERSITY
A
the wish to have only active channels
indicated or
the need of fault finding in case of RF
interference.interference
yes, return to normal operation. The
module is switched on as previously
described (see ch. 3.5.)
no, the module is to remain in the off-
state.
MENU
B
Y
N
SET
ESC
DISPLAY
4.1.9
(RX)
35