Download Print this page
Origaudio AQUATHUMP User Manual

Origaudio AQUATHUMP User Manual

Advertisement

Quick Links

W I R E L E S S S P E A K E R
1.
Volume Down (short press)
Previous Track (long press)
2.
Play / Pause (short press)
Power On / Off (long press)
3.
Volume Up (short press
Next track (long press)
4.
USB-C Charging Port
5.
3.5mm Audio Port
Turn on the speaker by holding the power
button (Figure 1.2) down for approximately 3
seconds; you should hear a power-up noise
and see a flashing blue LED light on the
front of the speaker to indicate that the
device is on and ready to pair. In the
wireless pair settings of your mobile device,
connect to the device named "Aquathump".
You will hear a noise and see the blue LED
light turn solid, ensuring a successful pair.
The speaker will automatically turn off if no
devices are paired after 13 minutes.
To connect to a new device, (while turned
off) hold down the power button for 5
seconds until you hear two beeps. This tone
means it's scanning for a new device.
Connect the USB charging cable to a power
source and insert the USB-C tip in the
charging port located underneath the port
flap. Let the Aquathump reach full charge
(approximately 2.5 hours if the battery was
completely drained) before use. The LED
light will turn red while the speaker is
charging, and turn off once fully charged.
▪ Wireless functionality with 33 foot range
▪ Up to 4 hours of audio playtime from a
single charge
▪ Built-in rechargeable battery
▪ Compatible with smart devices
▪ Waterproof when port flap is completely
sealed (submerged up to 1 meter)
▪ Carabiner clip for easy portability

Advertisement

loading
Need help?

Need help?

Do you have a question about the AQUATHUMP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Origaudio AQUATHUMP

  • Page 1 USB-C Charging Port charging port located underneath the port 3.5mm Audio Port flap. Let the Aquathump reach full charge (approximately 2.5 hours if the battery was completely drained) before use. The LED light will turn red while the speaker is charging, and turn off once fully charged.
  • Page 2 ▪ Do not put the electrical cords near water. different from that to which the receiver is ▪ Charging Time: 2.5 Hours connected. Although the Aquathump is waterproof ▪ Waterproof Rating: IPX67 —Consult the dealer or an experienced radio/TV under code IPX67, using the electrical technician for help.