Safety Considerations
Certification of RadarSens includes the following schemes (dependant on model):
Check the labels of the equipment for the presence of any required approvals marks prior to their use.
Note: Where the terms "Intrinsically Safe" or "ATEX" are used throughout this document, this must be understood to
mean the applicable intrinsic safety standards (ATEX, UKEX, IECEx) that are in force in country of installation.
Note: The installer is responsible for ensuring the logger and any connected equipment are certified for use and
are also compatible for interconnection
Note:
Before continuing, carefully read and follow the non-ATEX, general safety information in the "Safety Warnings and
Approvals Information" document supplied with the product. This document provides additional ATEX-related safety
information. Retain all documents for future reference.
Before using this product:
•
Make a risk assessment of the installation site and expected work activity.
•
Installations in a hazardous environment (e.g., ATEX) must be carried out by appropriate technicians with suitable
training for that environment.
•
It is the responsibility of the end user to take suitable precautions to prevent exposure to aggressive chemicals
that may attack the metals or polymeric materials used in the construction of this equipment.
The following materials are used in the construction of this equipment:
o
Enclosure:
o
Enclosure Labels: Polyester.
o
Gasket:
o
Connectors:
o
Cables:
o
Gland:
o
Fasteners:
o
Bracketry:
•
Ensure any tools necessary for installation are suitable for use within the hazardous environment.
•
Ensure suitable PPE (personal protective equipment) is used and that safe working practices are followed during
installation and any maintenance.
•
Check with the site owner or supervisor for any additional safety requirements before commencing work.
•
Ensure any communications device being used to assist in the install or setup of the logger is also suitable for use
in the hazardous environment in which you are working.
Before entering hazardous area:
•
Check the sensor and apparatus have the right approvals and certifications for use within the intended installation
environment.
•
Confirm the equipment has suitable ATEX markings and is being operated within its ATEX limits.
•
Check the port parameters of the relevant logger interface and the equipment to be attached. Confirm they are
suitable for interconnection.
•
Check the equipment includes a suitable cable with connector attached for interconnecting RadarSens to the
logger interface. A water-tight connection is required.
.
PC/ABS.
Silicone.
Nylon / Macromelt.
PVC.
Nylon.
Stainless Steel.
Stainless Steel.
Page 5 of 7
MANEX-170-0001-A (RadarSens Safety Supplement)
Need help?
Do you have a question about the RadarSens and is the answer not in the manual?