THOMSON ROC 550 Manual page 7

ROC 550 GB 18/07/02 10:36
If the B B (17) key is pressed twice within one second, and is held down for more than 2 seconds the second time,
then the remote control will send the OFF code for all modes.
7 - Controlling volume in satellite and cable mode
Since some satellite and cable receivers have no volume control, the
the television's volume in satellite or cable mode. For satellite systems with a volume control, it is possible to choose
the set that the MUTE (21) and VOL (19) keys will control in each of these modes: the television volume or the
volume of the satellite or cable receiver.
To choose, proceed as follows:
1. Press the TV key (the remote control must be in TV mode for this procedure).
2. Hold down the S (6) key until the last mode selected (TV) blinks 3 times and then
remains lit.
3. Release the S key.
4. Press the MUTE (21) key for around 8 seconds. The TV mode indicator light will
blink and go out for about 8 seconds before blinking once; at this point, release the
MUTE (21) key.
5. If the remote control previously controlled the television volume in SAT mode, it will
now control the volume of the satellite receiver; if it previously controlled the volume
of the satellite receiver, it will now control the television volume.
The THOMSON NAVILIGHT system allows you easy access to the settings of your
television (TV) or video recorder (VCR) including this feature.
1. Switch on the set you want to control.
2. Press the key corresponding to the type of set you want to use (TV, VCR, SAT or
AUX). In the VCR position, make sure that the AV mode is activated for the TV set
(the SCART socket must be selected).
3. Press key MENU (3) once.
4. Navigate through the setting menus with the keys up, down, left, right
(1 and 16).
5. Validate with OK (2).
6. To leave the menus, press key EXIT (18) once.
Page 5
6 - Other function: All modes OFF
8 - The NAVILIGHT system
5
remote control allows you to control
ROC 550