Valeton GP-200LT User Manual page 27

E ect List
FX Title Type
Step A 4-step auto filter machine for creating
Filter
Filter
OCTA Pitch Provides polyphonic octave effect.
Pitch Pitch Polyphonic pitch shifter/harmonizer.
P-Bend Pitch Polyphonic pitch shifter/harmonizer.
Based on classic Whammy®* monophonic
pitch shifter pedal. Assign the Position
Hammy Pitch
parameter to expression pedal, then move the
A ring modulator for creating intresting
Ring
Special inharmonic frequency spectra (like bells and
Mod
Vintage tape saturation simulater providing
Saturate Special
analog warmth and natural distortion.
This is an auto swell e ect with two
Auto
Special parameters that are easy to understand and
Swell
use. It can make the guitar sound like a violin.
This is a freeze e ect that can freeze the
sound for a short period of time before the
e ect is activated and make it play in a loop.
The Activate parameter can be assigned to the
Hold Special
expression pedal to activate and deactivate
the e ect; You can also turn on the Activate
parameter and use CTRL to directly control the
*The manufacturers and product names mentioned above are trademarks or registered trademarks of their respective owners.
The trademarks were used merely to identify the sound character of the products
Description
synth-like sounds
pedal to get the e ect.
chimes.
On/O of the e ect module.
PRE
Parameter Description
Step 1-4: Controls the filter center frequency of each step
Rate: Controls the sequencing speed
Sync: Switches Tap Tempo sync on/off
Low Oct: Controls the volume of lower octave (1 oct down)
High Oct: Controls the volume of higher octave (1 oct up)
Dry: Controls the dry signal level
Low/Hi Pitch: Controls the low/high pitch shifting range by
semitones
Dry: Controls the dry signal level
Low/Hi Vol: Controls the low/high pitch volume
Low/Hi Pitch: Controls the low/high pitch shifting range by
semitones
Wet: Controls the wet signal level
Dry: Controls the dry signal level
Range: Controls the pitch range of harmony effect
Range: Controls the pitch shifting range
Harmony: Switches Harmony mode (dry and wet signals output
simultaneously) on/o
Volume: Controls the e ect output volume
Position: Control the changes in pitch
Mix: Controls the wet/dry signal ratio
Freq: Controls the overall modulation frequency
Fine: Fine tune the modulation frequency by +/- 50Hz
Tone: Controls the e ect tone
Saturation: Controls the e ect gain
Mix: Controls the e ect wet/dry signal ratio
Volume: Controls the e ect output volume
High Cut: Cuts the e ect high frequency signal
Attack: Controls how fast the e ect swells
the input signal
Curve: Selects the volume swell curve (Line, Exp, Log)
Volume: Controls the e ect output volume
Activate: Switches the e ect on/o
25