Table of Contents
Advertisement
IFC228-LCD-DVD_EN
1/04/05
General operation
EN
16:20
Page 10
Switching the TV set on and off
l
To switch the TV set on, press the
left corner of the front.
If the indicator on the front is
- press the
on the remote control, or
- press the
channel or AV programme you were watching, or
- press the
watching.
When the set is on, the indicator on the front is
l
To put the TV set into standby mode, press the
set or the
indicator on the front is
consumption.
l
To switch off the TV set, press the
bottom left corner of the front
Volume
l
Volume control: use the Ã
+/-
button on the remote control to increase or decrease the volume.
l
Sound mute: press the
again or the
l
Headphone volume control: press the
the volume control bar.Then use the
volume control bar. Use the
Accessing channels
l
Using the numeric buttons:
- for channels 1 to 9, press the corresponding button;
- for channels 10 to 99,
- press the tens digit for a few seconds to display it on the screen, then press the
units digit. For instance, for programme 24, press and hold 2 to display 2-, then
press 4; or
- press the
l
Using the
included in the cycle unless you use the buttons on the side of the TV set.
l
Using the list of programmes: refer to page 11.
To access the channel or AV programme previously being watched, press the
button.
Accessing AV programmes
AV
Press the
the other audio-visual programmes.
AV selection loop: AV1, AV2, AV3 (depending on model),VGA, DVI, CMP (= component,
YPrPb or YCrCb).
O Demo mode
This mode is used to highlight the benefits of the Hi Pix setting.
DEMO
Press the
Hi Pix
setting. Press again the
not press any button for 12 seconds, the TV set alternates between on and off with the Hi
Pix setting. Press the
To exit Demo mode, press any button on the remote control except
DEMO
.
The Hi Pix setting is activated by default.
button located on the side or on the bottom
red
, the set is in standby mode.You can then:
button on the side of the TV set, the
TV
,
OK
or
PR+/PR-
buttons to switch the television on at the last
AV
button to switch the television on at the last AV programme you were
button on the remote control.When the set is in standby mode, the
red
.The TV set remains powered up, but with low energy
button located on the side of the set or on the
.
¨ buttons on the side of the TV set or press the
VOL
button to temporarily mute the sound. Press this button
+
button to restore it.
+/-
buttons to adjust the volume.
0
button to display "--", then enter the two digits.
PR+/PR-
buttons: scroll through the channels. AV programmes are not
button to display the last selected audio-visual programme and scan through
button on the remote control to switch to Demo mode and activate the
DEMO
button to deactivate the Hi Pix setting. If you do
DEMO
button to manually activate/deactivate the setting.
10
or any numeric button
green
.
button on the side of the TV
button on the remote control to display
buttons to switch to the headphone
RETURN
+/-
,
, and
Advertisement
Table of Contents
